D3 EZ-Bell Kullanıcı Kılavuzu - Sayfa 3

Aksesuarlar D3 EZ-Bell için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. D3 EZ-Bell 7 sayfaları. Doorbell camera

6. Requirement

Power



10-30VAC,

10VA or 12VDC, 0.5 to 1.0A wired to an in home mechanical or digital doorbell

chime. Note: A Digital Doorbell Adapter must be installed if a digital doorbell chime is present.

WARNING: An in-line resistor (10 Ohm, 10 Watt) is required when installing the doorbell camera

without a wired, in-home doorbell chime. This is typically done when testing the doorbell or

performing a demonstration. Failure to install a resistor when a chime is not present may result

in damage to the doorbell camera.

Chime



Security Panel (XP02) as Chime - XP02 Panel can be a chime of the EZ-Bell doorbell.



Mechanical Chime - If the chime has metal bars and a striker pin, it is mechanical and



will work without additional hardware.

Digital Chime - If the chime has a speaker that plays a tone when pressed, it is digital



and will require the installation of the Digital Doorbell Adapter and the enabling of the

digital doorbell setting in the app to function properly.

Tube Chime - If the chime has a series of tubular bells, it is a tube chime and is



incompatible with the doorbell camera.

Intercom System - If the doorbell button fixture includes a speaker, it is an intercom



system and is incompatible with the doorbell camera.

No Chime - If there is no chime in the system, the customer will only receive alerts on



their phone and a resistor (10 Ohm 10 Watt) must be used in-line with the doorbell

camera.

WiFi



A Wi-Fi Internet upload speed of at least 1.5 Mbps is required at the location where the doorbell

camera is installed.

Note: In Canada when using 5 GHz on band 1, the device is intended for indoor use only.

Confidential for D3 Internal Use Only