Domyos VE 170 Kullanım Talimatları Kılavuzu - Sayfa 13

Eliptik Eğitmen Domyos VE 170 için çevrimiçi göz atın veya pdf Kullanım Talimatları Kılavuzu indirin. Domyos VE 170 16 sayfaları.
Ayrıca Domyos VE 170 için: Kullanım Talimatları Kılavuzu (16 sayfalar), Kullanım Talimatları Kılavuzu (16 sayfalar)

Sayfayı Yazdır

Domyos VE 170 Kullanım Talimatları Kılavuzu

Warning: You need to get off the elliptical bike before moving it.

Stand facing the front of the bike, hold the handlebar and pull the bike towards you. Your bike now rests on the castors and you can move

it. When you have ﬁ nished moving it, hold on to it until the back feet are back on the ground.

According to EN deﬁ nition, this product is a «speed independent product». You can adjust the braking torque not only through the pedal-

ling frequency, but also by choosing the resistance level manually (by turning the torque controller button on non-motorized products, by

pressing the up/down buttons on motorized products). Nevertheless, if you keep the same resistance level, the braking torque will increase/

decrease as your pedalling frequency increases/decreases.

1. Remove the console from its holder, remove the battery co-

ver at the rear of the product and insert two AA/UM-3 bat-

teries into the compartment at the back of the screen.

2. Ensure that the batteries are inserted correctly and that they

are in full contact with the springs.

3. Replace the battery cover and the console, ensuring that

they are correctly attached.

4. If the display is unreadable or incomplete, remove the batte-

ries, wait for 15 seconds and then replace them.

5. When you remove the batteries, the console memory is

erased.

RECYCLING :

The "crossed-out wastebasket" symbol indicates that this pro-

duct and the batteries it contains cannot be thrown away with

household waste.

They are subject to a speciﬁ c type of sorting.

At the end of their lives, take your batteries and your electronic

product to an approved collection site to recycle them.

This treatment of your electronic waste will protect the environ-

ment and your health.

M OVING YOUR P ROD U C T

ADJU STMEN TS

LEVELLING THE BIKE

Warning: You need to get off the elliptical bike before levelling it.

In the event that the product becomes unstable during use, turn one of the level correc-

tors until it is stable again.

ADJUSTING THE RESISTANCE

Resistance is adjusted using the thumb wheel graded from 1 to 8.

Position 1 corresponds to the lowest resistance, and position 8 to the highest.

You can vary the resistance while pedalling.

FC100 CONSOLE

I N STALL IN G BATT E R I ES