D3FY SPORTS VERT3X Kullanıcı El Kitabı - Sayfa 8

Aksesuarlar D3FY SPORTS VERT3X için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. D3FY SPORTS VERT3X 16 sayfaları. .68 caliber paintball marker

Sayfayı Yazdır

and Striker from the rear of the Receiver.

Tip: Only remove the Striker Plug with the marker in the un-cocked

position. This will prevent the internals from springing out when the

Striker Spring is compressed.

Note: The Striker Plug and Velocity/Spring Guide will come out

as one piece.

3. Remove the following items in order; Striker Spring, Striker Buffer,

and Striker

4. Clean any dirt, debris, or paint from the inside of the Receiver.

5. Wipe the Delrin Bolt and Striker with a clean cloth. Apply a few drops

of oil to the Striker O-ring (O-03).

REASSEMBLE REAR INTERNALS

1. Insert the Striker with the O-ring end facing in first and the flat spot of

the Striker facing downwards.

Note: the Striker will only go in half way because of the Trigger Frame

Sear. Apply pressure behind the Striker with your thumb and at the

same time pull the trigger to release the Sear, this will allow the Striker

to insert all the way.

2. Insert the Striker Buffer so that it is flush with the Receiver and insert

the Striker Spring.

3. Insert the Velocity/Spring Guide into the Striker Spring, which is

connected to the Striker Plug and firmly tighten the Striker Plug to the

Receiver.

Ⅰ MAINTAINING YOUR CONQU3ST PAINTBALL MARKER (CONTINUED)

4. Insert the Delrin Bolt with the open face in first. Align the Bolt

Cocking Pin with the Striker hole, and push down on the Pin to lock it

in place.

Note: If the Striker hole is not aligned upright, the Bolt Cocking Pin will

not lock correctly.

WARNING Before and after using the marker, make sure to fasten all

screws. Screws may become loose due to vibration caused by firing

the marker. Loose screws can cause parts to detach from one another,

which can be dangerous and cause injury.

To assure that the marker is assembled properly, follow the schematic

drawing and position parts in order during assembly. Parts assembled

improperly or using improper parts will/can cause the marker to

malfunction.

DISASSEMBLE FRONT INTERNALS

Make sure all paintballs are removed from the marker and that the

air source is detached before attempting any maintenance and/or

repairs.

1. Remove the Barrel (X-21) by unscrewing it counter-clockwise.

2. Remove Front Plug Screw (S-19) using a 3mm Allen key. This

screw holds the Front Plug (X-05) onto the Receiver.

3. Pull the Front Plug out of the Receiver.

CUP SEAL REMOVAL

PART # and Description

(X-21) 30.48cm (12") Barrel

(X-05)Front Plug

(I-01)Valve Spring

(I-02)Cup Seal/Valve Pin

(S-19)Front Plug Screw