Da-Lite 29526 Talimat Kitabı - Sayfa 13

Projeksiyon Perdesi Da-Lite 29526 için çevrimiçi göz atın veya pdf Talimat Kitabı indirin. Da-Lite 29526 14 sayfaları.

Installation (continued)

30. Assemble the six provided trim pieces (P). The two top pieces

will be labeled "A" at the 45 degree overlap and the two

bottom pieces will be labeled "B". The remaining two pieces

are for the sides and are interchangeable.

31. Starting at the audience side bottom right corner, align the

first piece of bottom trim (P) with the bottom edge of the

screen. The end should be approximately 3" from the corner

of the wall opening. When aligned, snap the trim (P) onto the

T-track while moving along the length of the piece until firmly

in place. Align the second bottom piece of trim (P) at the 45

degree overlap and snap onto the T-track starting at the

overlap while moving along the length of the piece until

firmly in place (Figure 10).

NOTE: Custom screens may use three pieces.

Corner

Cover

Trim Pieces

45 Degree

Overlap

32. Starting at the audience side bottom left corner, align a side

piece of trim (P) with the side edge of the screen. The end

should be approximately 3" up from the corner of the wall

opening. When aligned, snap the trim (P) onto the T-track

while moving along the length of the piece until firmly in

place (Figure 10).

33. Repeat Step 31 for the top trim pieces (P) and Step 32 for the

audience right trim piece (P) (Figure 10).

34. Place corner covers (Q) over each corner to check fit and

alignment. Adjust trim if necessary. When satisfied with

desired placement of all four corner covers (Q), peel the red

release liners from the two pieces of adhesive and firmly

press each corner cover into place (Figure 10).

35. Carefully remove the protective paper on the projector side

of the screen surface to complete the installation.

Figure 10

Trim

T-Track