Da-Lite ACOUSTICAL IMAGER Talimat Kitabı - Sayfa 11
Projeksiyon Perdesi Da-Lite ACOUSTICAL IMAGER için çevrimiçi göz atın veya pdf Talimat Kitabı indirin. Da-Lite ACOUSTICAL IMAGER 13 sayfaları.
Sayfayı Yazdır
TROUBLESHOOTING
SYMPTOM
1. No sound from any of the speakers
2. There is no sound coming from one speaker.
3. There is no sound from the center speaker.
SOLUTION
(a) Check that receiver/amplifier is on and a source is
playing.
(b) Check that the powered subwoofer is plugged in, and
it's Power switch is switched on ("•" position).
(c) Check all wires and connections between receiver/
amplifier and speakers. Make sure all wires are
connected. make sure none of the speaker wires are
frayed, cut or punctured, or touching each other.
(d) Review proper operation of your receiver/amplifier.
(a) Check the "Balance" control on your
receiver/amplifier.
(b) Check all wires and connections between
receiver/amplifier and speakers. Make sure all wires
are connected. Make sure none of the speaker wires
are frayed, cut or punctured, or touching each other.
(c) In Dolby Digital or DTS modes, make sure that the
receiver/processor is configured so that the speaker
in question is enabled.
(c) Turn off all electronics and switch the speaker in
question with one of the other speakers that is
working correctly. Turn everything back on, and
determine whether the problem has followed the
speaker, or has remained in the same channel. If the
problem is in the same channel, the source of the
problem is most likely with your receiver or amplifier,
and you should consult the owner's manual for that
product for further information. If the problem has
followed the speaker, consult your dealer for further
assistance or, if that is not possible, contact Da-Lite
Screen Company.
(a) Check all wires and connections between receiver/
amplifier and speaker. Make sure all wires are
connected. Make sure none of the speaker wires are
frayed, cut or punctured, or touching each other.
(b) If your receiver/processor is set in Dolby Pro Logic
mode, make sure the center speaker is not in
phantom mode.
(c) If your receiver/processor is set in one of the Dolby
Digital or DTS modes, make sure the receiver/
processor is configured so that the center speaker is
enabled.
10