Da-Lite ADVANTAGE ELECTROL Talimat Kitabı - Sayfa 6
Projeksiyon Perdesi Da-Lite ADVANTAGE ELECTROL için çevrimiçi göz atın veya pdf Talimat Kitabı indirin. Da-Lite ADVANTAGE ELECTROL 12 sayfaları. Tensioned large
Ayrıca Da-Lite ADVANTAGE ELECTROL için: Talimat Kitabı (12 sayfalar), Montajcı El Kitabı (2 sayfalar), Talimat Kitabı (4 sayfalar), Talimat Kitabı (12 sayfalar), Talimat Kitabı (16 sayfalar)
Sayfayı Yazdır
ADVANTAGE
ELECTROL
®
240 VOLT WIRING DIAGRAM FOR STANDARD
WALL SWITCH:
Da-Lite offers two styles of 240 volt wall
switches for standard operation. Please see
wiring diagram included in wall switch box
included with screen.
s
!
CAUTION: THE PROJECTOR MUST BE TURNED OFF BEFORE CONNECTING THE TRIGGER WIRES TO THE PROJECTOR. FAILURE
TO DO SO MAY DAMAGE THE CONTROLLER.
1. Use 2-conductor 20-24 gauge wire to extend the low voltage connection from the projector's 5 or 12-volt screen
trigger output to the length required to reach the VPI. When extending the low voltage connection from the
projector's screen trigger output, be sure to maintain the proper polarity. The red wire from the VPI is the "signal"
and the black wire from the VPI is the "ground" .
2. Connect the wires from the VPI that are labeled "Low Voltage Connection" to the end of the extended screen
trigger wires above.
240V WIRING DIAGRAM
WITH OPTIONAL BUILT-IN
LOW VOLTAGE CONTROL
BLUE
(COMMON)
BROWN
240VAC 50HZ
GREEN
GROUND–MUST BE
CONNECTED TO
BUILDING GROUND
ILT RJ9 PIN-OUTS
(TAB IS FACING UP)
IR or UP
BLACK
GND COMMON
RED
+5V
GREEN
DN or DATA
WHITE
INSTALLATION FOR 220/240V SCREENS
®
FIGURE 6
(HOT)
GREEN
GROUND TO CASE
IMPORTANT NOTE: The wall switch is REQUIRED to make any limit
240V WIRING DIAGRAM WITH
OPTIONAL BUILT-IN VIDEO
PROJECTOR INTERFACE
240VOLT AC/ 50HZ
POWER SOURCE
GREEN/YELLOW
(GROUND)
BLACK
WHITE
FRONT OF
BACK OF WALL
WALL SWITCH
SWITCH
UP
STOP
DOWN
OPTIONAL IR AND RF
REMOTE CONTROL
MOTOR
RJ9
SPLITTER
DRY CONTACTS
switch adjustments, EVEN if a third party control
system is used. Therefore, it is advised to wire the
switch or provide a 4-conductor connection that is
accessible.
5
BROWN
(HOT)
BLUE
(COMMON)
RED
RED
BLACK
5/12 VOLT SCREEN
TRIGGER ON PROJECTOR
LOW-VOLTAGE WALL SWITCH
UP
STOP
RJ9
DOWN
FRONT
GREEN/YELLOW
(GROUND)
BROWN
(DOWN)
BLUE
(COMMON)
BLACK (UP)
FIGURE 7
UP DN
GND +5V
3-POSITION
RJ9
SWITCH
BACK
FIGURE 8