Da-Lite LARGE ADVANTAGE DELUXE ELECTROL Talimat Kitabı - Sayfa 2
Projeksiyon Perdesi Da-Lite LARGE ADVANTAGE DELUXE ELECTROL için çevrimiçi göz atın veya pdf Talimat Kitabı indirin. Da-Lite LARGE ADVANTAGE DELUXE ELECTROL 8 sayfaları. Automatic electric projection screen
Ayrıca Da-Lite LARGE ADVANTAGE DELUXE ELECTROL için: Spesifikasyon Verileri (2 sayfalar), Talimat Kitabı (10 sayfalar), Talimat Kitabı (13 sayfalar)
Sayfayı Yazdır
When using your video equipment, basic safety precautions should always be followed, including the
following:
1. R ead and understand all instructions before using.
2. Close supervision is necessary when any appliance is used by or near children. Do not leave
appliance unattended while in use.
3. Do not operate appliance with a damaged cord or if the appliance has been dropped or damaged –
until it has been examined by a qualified serviceman.
4. P osition the cord so that it will not be tripped over, pulled, or contact hot surfaces.
5. If an extension cord is necessary, a cord with a current rating at least equal to that of the appliance
should be used. Cords rated for less amperage than the appliance may overheat.
6. To reduce the risk of electric shock, do not immerse this appliance in water or other liquids.
7 . To reduce the risk of electric shock, do not disassemble this appliance. Contact an authorized
service dealer when repair work is required. Incorrect reassembly can cause electric shock when
the appliance is used subsequently.
8. The use of an accessory attachment not recommended by the manufacturer may cause a risk of
fire, electric shock, or injury to persons.
PRE-INSTALLATION
1. Carefully unpack screen and remove outer wrapping from case.
2. Make sure to recheck measurements of screen location before installation.
Please Note: Motor Operator Projection Screen Models LADT, LADDT, LAD
and LADD must be installed in accordance with the requirements of the
Local Building Codes, the Canadian Electrical Code (CEC), CAN/CSA C22.1
and the National Electric Code (NEC), NFPA 70. An appropriate disconnect
device shall be provided as part of the building installation.
CASE INSTALLATION
1. The case provides multiple attachment points for bolts, cables, or threaded rod. Page 5 shows threaded rod
installed. The variable position-mounting bracket may be located anywhere along the length of the case. It is
recommended to keep the brackets spaced evenly enough to distribute the weight of the screen. One mounting
bracket is required for every 4' of case length.
The case has a self-trimming flange around the bottom. Ceiling tiles or drywall may be placed on top of this flange
to provide a finished appearance.
2. After securing the case in the ceiling check that the case is level and plumb.
3. Install electrical connections that apply to your unit. Review the wiring diagrams on page 4 for proper installation.
IMPORTANT SAFETY INSTRUCTIONS
SAVE THESE INSTRUCTIONS
BOLTS
1
DOOR SUPPORT SCREWS
(NOT ALL SIZES)
ACCESS
DOOR
FIGURE 1