Da-Lite Large Dual Masking Electrol Talimat Kitabı - Sayfa 3

Projeksiyon Perdesi Da-Lite Large Dual Masking Electrol için çevrimiçi göz atın veya pdf Talimat Kitabı indirin. Da-Lite Large Dual Masking Electrol 8 sayfaları.

Sayfayı Yazdır

Pre-Installation

Carefully unpack screen.

2. Make sure to recheck measurements of screen location

before installation.

Drywall Screw

Access Panel

Machine Screw

Figure 1

Installation

NOTE: Unit is not to be installed in air handling space.

Hangers (If required)

Make sure hangers are placed to fit into the

pre-determined notches.

2. Level unit lengthwise with a carpenter's plum level.

CAUTION! Do not completely seal in unit. Access room must

be allowed for motor repair or fabric replacement.

ATTENTION! Ne fixez pas complètement l'unité. Un espace doit

être laissé pour pouvoir réparer le moteur ou remplacer la

toile.

3. Remove the slat retainer brackets from the front of the case (Fig. 3).

4. Remove wrapping paper and tape strips.

CAUTION! Do not cut wrapping paper or tape with knife

or any sharp tool. Remove by hand.

ATTENTION! Ne coupez pas le papier d'emballage ou le ruban

adhésif avec un couteau ou un outil tranchant. Retirez à la

main.

5. Install electrical hook up that applies to your unit. Make sure to

review your Electrical Installation Checklists and wiring diagrams

(included) for either 110 volt switch, 220/240 volt switch, or DRC

low voltage control.

3. Do not remove the wrapping paper or pull the orange string

until the screen is installed.

Screens 14' wide and over use an ironing board to flatten the

fabric. The ironing board is part of the access panel (Fig. 3).

Adjustment

Knob "Down"

Mask Motor

Wiring Box

Screen Motor

Wiring Box

Adjustment

Knob "Up"

NOTE: Must be installed in accordance with the requirements of

the Local Building Codes, the Canadian Electrical Code (CEC), CAN/

CSA C22.1 and the National Electric Code (NEC), NFPA 70. An

appropriate disconnect device shall be provided as part of the

building installation.

6. Test installation by carefully running surface up and down several

times. Be prepared to stop screen. Standard Duty Cycle: 1 MIN. ON /

10 MIN. OFF.

NOTE: The picture surface, when rolled down, should have at least

a full wrap and a half around the roller. Do not allow any part of the

roller to become exposed.

Ironing Board

(Screens 14' Wide And Over)

Figure 2

Slat Retainer

Brackets

(3 Screws)

Figure 3