Da-Lite Parallax Thin Talimat Kitabı - Sayfa 3

Projeksiyon Perdesi Da-Lite Parallax Thin için çevrimiçi göz atın veya pdf Talimat Kitabı indirin. Da-Lite Parallax Thin 4 sayfaları.

Wall Mounting Instructions

NOTE: The screen is shipped with two wall brackets. Screens in

widths of 88¾" and below receive (2) 28" wall brackets. Screens

above 88¾" in width receive (2) 44" wall brackets. Use appropriate

mounting hardware for the wall type and to accommodate for

the screen's hanging weight (Figure 1).

Secure the two wall brackets to wall studs at the desired height.

The outside edge of each wall bracket must be no greater than 5"

away from the left and right edges of the frame. You will need at

least 2" clearance above the drilled holes to hang the screen

(Figure 1) .

2. To install the striker plate, take your screens overall height

(including frame) and subtract 1¼". Using that dimension, measure

down from the top edge of the wall brackets and mark the wall

for a screw hole (Figure 1).

NOTE: Make sure your mark corresponds with where you intend

the center of your image to be once the screen is fully installed.

Figure 1

3. Secure the striker plate to the wall at the marked locations.

NOTE: Make sure the screw head is flush to the face of the striker

plate so that the full pull force of the magnet is acheived.

4. With two people, one on either end of the screen, lift the screen

onto the wall. Making sure the wall brackets are securely seated in

the back of the screens frame.

5. Slowly lower the bottom of the screen, making sure the center of

the screen is aligned with the striker plate on the wall.

CAUTION: Pinch Hazard. While lowering the screen, be

careful to keep your fingers clear of the magnet and striker

plate.

Striker Plate

Overall Height Less 1¼"