Da-Lite Advance 26P Pivoting Da-Lift 33P Manuel - Sayfa 5
Projektör Aksesuarları Da-Lite Advance 26P Pivoting Da-Lift 33P için çevrimiçi göz atın veya pdf Manuel indirin. Da-Lite Advance 26P Pivoting Da-Lift 33P 7 sayfaları.
Sayfayı Yazdır6. Determine where the projector will be
located and make a hole in the ceiling
and create a tile for the Da-Lift. See
Figure 3 & 8.
7. Attach Da-Lift to structural ceiling. See
Figure 9.
8. Lower Da-Lift by connecting the power
supply to 120 volt or 220 volt AC power.
Use the switch shown to operate the Da-
Lift. See Figure 10. The "Stop" button is
needed only for intermediate stopping.
WARNING! Avoid pinch points when
operating Da-Lift with built-in switch.
9. Power the projector and adjust projector
location.
DA-LIFT MODEL
26P
33P
NOTE:
CUT-OUTS ARE SQUARE.
TOLERANCES ARE ±1/8".
TRIM PIECE
HAS TO FIT
INSIDE CUT-OUT
Figure 8
CHANNEL
NOTE: ITEMS CALLED
OUT ARE NOT SUPPLIED
Figure 9
Figure 10
"A"
"B"
16-1/2"
15-3/8"
21"
19-7/8"
TILE HAS TO
FIT INSIDE
CEILING TILE HOLDER
"UP"
CEILING TILE HOLDER CAP
CUT-OUT
"A"
SCRAP
"B"
3/8" ALL-THREAD
3/8" HEX NUT
3/8" FLAT WASHER
3/8" FLAT WASHER
3/8" LOCK HEX NUT
CONNECT TO
120V AC OR
220V AC.
"STOP"
"DOWN"
WARNING!
AVOID PINCH POINTS
WHEN OPERATING DA-LIFT
WITH THIS SWITCH