Da-Lite TENSIONED CONTOUR ELECTROL Kullanım Kılavuzu - Sayfa 6
Projektör Aksesuarları Da-Lite TENSIONED CONTOUR ELECTROL için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. Da-Lite TENSIONED CONTOUR ELECTROL 9 sayfaları. Installer friendly features
Ayrıca Da-Lite TENSIONED CONTOUR ELECTROL için: Talimat Kitabı (13 sayfalar), Talimat Kitabı (9 sayfalar), Montajcı El Kitabı (2 sayfalar), Talimat Kitabı (13 sayfalar)
TENSIONEd CONTOUR
®
120V WIRING DIAGRAM
WITH OPTIONAL BUILT-IN
LOW VOLTAGE CONTROL
LED
UP LIMIT
TACTILE
BUTTON
U P
S T O
P
D O W
N
DOWN LIMIT
TACTILE
BUTTON
FRONT OF
BACK OF
WALL SWITCH
WALL SWITCH
3-conductor 20-24 gauge wire can be used in place of
the supplied RJ-14 cable to connect the wall switch.
Connect the bus terminals on the wall switch to the
corresponding bus terminals on the splitter board.
IMPORTANT NOTE:
The wall switch is ReQuIRed to make any limit switch
adjustments, eVen if a third party control system is
used. Therefore, it is advised to wire the switch or
provide a 3-conductor connection that is accessible.
240V WIRING DIAGRAM
WITH OPTIONAL BUILT-IN
LOW VOLTAGE CONTROL
BLUE
(COMMON)
BROWN
(HOT)
240VAC 50HZ
GREEN
GROUND–MUST BE
CONNECTED TO
BUILDING GROUND
ILT Rj9 PIN-OUTS
(TAB IS FACING UP)
IR or UP
BLACK
GND COMMON
RED
+5V
GREEN
DN or DATA
WHITE
ELECTROL
INSTALLATION
®
Rj-22
INPUTS
Rj-22
jACK
BUS
GREEN
GROUND TO CASE
IMPORTANT NOTE: The wall switch is ReQuIRed to make any limit
Rj-14 PIN-OUTS
(TAB IS FACING UP)
BUS (RP DATA)
RQ DATA
+5V
GND
Rj-22
jACK
Supplied Rj-14 cable
Rj-22
OUTPUT
UP
DOWN
COMMON
BUS
5V
Rj-45
RECEPTACLE
Rj-45 jACK
POWER WIRE
BLACK (HOT)
WHITE (COMMON)
POWER INPUT 120VAC / 60HZ
OPTIONAL IR AND RF
REMOTE CONTROL
MOTOR
Rj9
SPLITTER
DRY CONTACTS
switch adjustments, eVen if a third party control
system is used. Therefore, it is advised to wire the
switch or provide a 4-conductor connection that is
accessible.
5
Rj-22 PIN-OUTS
(TAB IS FACING UP)
+12V
WHITE
BUS (RP DATA)
GREEN
RQ DATA
RED
+5V
BLACK
GND
RQ CLOCK
Standard Rj-22 can be used in place of Rj-14
Rj-45 PIN-OUTS
(TAB IS FACING UP)
DRY CONTACTS
MANUAL 2
BUS
+12V
BUS (RP DATA)
RQ DATA
+5V
GND
RQ CLOCK
DATA
MANUAL 1
CABLE
GREEN (GROUND)
GROUND–MUST BE
CONNECTED TO
BUILDING GROUND
LOW-VOLTAGE WALL SWITCH
UP
Rj9
STOP
DOWN
FRONT
BLUE
YELLOW
GREEN
RED
BLACK
WHITE
BROWN
BLUE
YELLOW
GREEN
RED
BLACK
ORANGE
PURPLE
UP DN
GND +5V
3-POSITION
Rj9
SWITCH
BACK