Daavlin 1 Series Kullanım Kılavuzu - Sayfa 10
Tıbbi Ekipman Daavlin 1 Series için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. Daavlin 1 Series 19 sayfaları. Modes of operation - timed mode
Sayfayı Yazdır10.3 How to Position Yourself
Dual Point Calibration Selection: The 1 Series has been designed to deliver accurate and
effective treatments from two distinct treatment distances. Treatments can be administered
directly on the acrylic's surface (0 inches) or at a distance of nine inches from the acrylic (9 inches
or 23 centimeters).
The intensity or power output of the device will be much greater when treating directly on the
acrylic surface versus treating from nine inches away. For this reason, you must select the desired
treatment distance before administering a treatment. See specific instructions under Running a
Treatment.
By selecting the treatment distance, 0 in or 9 in, you are telling the system how it should calculate
the length of the treatment based on your distance from the lamps.
Hands and Feet: (Choose 0 inches position when starting your therapy). Position the device on
a flat surface with the lamps facing up. Place your hands or feet directly on top of the plastic lamp
guard. For the best results you should position your hands, or feet, as close as possible to the
center of the fixture.
Note: When treating the hands and feet be careful not to place too much weight or pressure on
the acrylic surface. Excess pressure can cause the acrylic surface to crack and break.
Larger Area Treatment: (Choose the 9 inches position when starting your therapy). Position
the 1 Series so that the lamps are perpendicular to the surface on which the device is standing
on. Position the part of your body that you wish to treat nine (9) inches away from the lamps.
11.0 Setting Up a Treatment Time
1. Enter in your key code. Unless you have changed it, the factory default key code is "0007."
2. Once the key code has been entered, the display should read "00:00".
3. The currently editable character will flash on and off to signal that it is the editable
character.
4. Press the UP-ARROW button to increase the value of the flashing character by one (1).
5. Press the LEFT ARROW button to move the flashing character over by one position.
6. Once the desired time is present on the display, press the PLAY/PAUSE button to lock-in
the treatment time.
7. Press the PLAY/PAUSE button to begin the treatment.
8. Press the PLAY/PAUSE button to pause the treatment.
9. While treatment is paused or completed, press the CANCEL button to return to the
treatment menu ("00:00" displayed with the right-most character flashing).
10. After a treatment is complete, the controller will enter Standby Mode. The controller will
flash the most recently completed treatment while in standby mode.
a. To repeat this treatment: press the PLAY/PAUSE button to re-enter Time Entry
Mode. The rightmost character should now be flashing.
MNL-00049 [1]
Proprietary and Confidential. Printed copies will not be updated.
Page 10 of 19