Ekinex EK-GD2-TP-1-HV Hızlı Başlangıç Kılavuzu - Sayfa 2

Dimmer Ekinex EK-GD2-TP-1-HV için çevrimiçi göz atın veya pdf Hızlı Başlangıç Kılavuzu indirin. Ekinex EK-GD2-TP-1-HV 6 sayfaları. Telesin gp-wtp-905

Sayfayı Yazdır

Accessories

Rail-mounting support

The device EK-GD2-TP-1-HV can be mounted on 35 mm

rail (according to EN 60715) with the plastic support inclu-

ded in the delivery.

Control, signaling and connection elements

The device is equipped with a screw terminal for connec-

ting the 90 - 230 Vac output loads (1), the 90 - 230 Vac

input power supply (2), a screw terminal for connecting

the KNX bus line (4) and a KNX programming / test but-

ton with a LED under the cover (5) . The pair of terminals

(3) is not used.

EK-GD2-TP-1-HV

IN: 90-230 VAC 50/60Hz

OUT: 1A

Made in Italy

AC OUT

EK-GD2-TP-1-HV

Nr.

Label

Connection

AC Output - Live

AC OUT (N)

AC Output - Neutral

AC IN (N)

AC Input - Neutral

AC IN (L)

AC Input - Live

Not used

KNX bus terminal

Test / KNX programming button and LED

Mounting

The devices have degree of protection IP00 and are the-

refore suitable for use in dry interior rooms.

The 1-channel model is suitable for installation in wall-

mounting boxes. The plastic support allows mounting on

a profile rail according to EN 60715 inside electrical distri-

bution panels and cabinets.

AC IN

Before removing the device, make sure that inputs, ou-

tputs, and the AC power supply have been disconnected.

When assembling, make sure to leave only the front pa-

nel accessible; all other sides must not be accessible. For

the mounting proceed as follows:

• Insert the mounting support in the appropriate shaped

profile of the back side of the device

• then hook the teeth to the profile guide starting from

the bottom

• finally, push the upper part towards the guide for final

coupling.

Before removing the device, be sure that inputs, outputs,

and the input power supply have been disconnected. Use

a screwdriver to slide down the locking device and remo-

ve the device from the rail.

Note. When mounting the device in boards and ca-

binets it shall be provided the necessary ventilation

so that the temperature can be kept within the ope-

rating range of the device.

Setup and installation

The steps to setup the device are as follows:

1. Connect the loads to the AC OUT (

of the device

2. Connect the KNX bus to the corresponding terminal of

the device

3. Connect the 90 - 230 Vac power supply to the AC IN (L,

N) terminals of the device

KNX bus line connection

The connection to the bus network takes place via the

KNX terminal included in the delivery and inserted in the

special housing located on the front of the device in the

upper part.

Characteristics of the KNX terminal block

• spring clamping of conductors

• 4 seats for conductors for each polarity

• terminal suitable for KNX bus cable with single-wire

conductors and diameter between 0.6 and 0.8 mm

• recommended wire stripping approx. 5 mm

• color codification: red = + (positive) bus conductor,

black = − (negative) bus conductor

-x, N) terminals