Dongcheng Z1C-FF05-26C Çalıştırma Talimatları Kılavuzu - Sayfa 4
Matkap Dongcheng Z1C-FF05-26C için çevrimiçi göz atın veya pdf Çalıştırma Talimatları Kılavuzu indirin. Dongcheng Z1C-FF05-26C 11 sayfaları.
Sayfayı Yazdır
6. Under normal operation, the tool is designed to produce vibration. The screws
can come loose easily, causing a breakdown or accident. Check tightness of
screws carefully before operation.
7. Under normal operation, the tool is designed to produce vibration. The screws
can come loose easily, causing a breakdown or accident. Check tightness of
screws carefully before operation.
8. Always be sure to have a firm footing. Wear safety belt when using this tool in
high locations and ensue no one is below.
9. Keep hands away from the rotating parts.
10. Do not leave the tool running. Operate the tool only when hand-held.
11. Do not point the tool at any one in the area when operating. The bit could fly
out and injure someone seriously.
12. Do not touch the bit or parts close to the bit immediately after operation; they
may be extremely hot and could burn your skin
SAVE THESE INSTRUCTIONS.
WARNING! MISUSE or failure to follow the safety rules stated in this
instruction manual may cause serious personal injury.
INSTRUCTIONS FOR OPERATION
Setting Operating Mode
Caution:
Always be sure that the tool is switched OFF before changing the operating
mode, or the gears inside the tool maybe damaged.
If the drill bit gets stuck by the steel hidden in the wall during impact drilling, and
the tool rotates due to the kickback, hold the handle and auxiliary handle firmly
to avoid personal injuries.
The Operating mode can be changed by turning the
operating mode selector.
Drilling Operation
-5-
When impact drilling on the concrete or stone, turn the selector to the position as
shown in the figure.
When normally drilling on the wood, metal, ceramics or
plastic, turn the selector to the position as shown in the
figure.
Demolition Operation
When the position of chisel needs adjusting during
operation, turn the selector to the position as shown in the
figure to avoid gears from meshing and then adjust the
chisel.（Z1C-FF05-26/Z1C-FF05-26B）
After adjusting the chisel, turn the selector to the position
as shown in the figure to restart demolition operation.
Installing SDS-plus Hammer Drill Bit
SDS-plus hammer drill bit can be used
when drilling on the steel, wood or plastic.
Screw the drill chuck in the connecting rod
and tighten the lock screw. Then insert the
connecting rod into the collect in the same
way as installing SDS-plus hammer drill bit.
SDS-plus hammer drill bit and drill chuck
are optional accessories. (Fig. 1)
Installing /Removing Drill Bit
-6-