Dongcheng DSM03-115 Çalıştırma Talimatları Kılavuzu - Sayfa 3
Öğütücü Dongcheng DSM03-115 için çevrimiçi göz atın veya pdf Çalıştırma Talimatları Kılavuzu indirin. Dongcheng DSM03-115 6 sayfaları.
Sayfayı Yazdır
18. Do not use tool if switch does not turn it on or off. Any power tool that
cannot be controlled with the switch is dangerous and must be repaired.
19. Disconnect the plug from the power source and/or the battery pack from
the power tool before making any adjustments, changing accessories, or
storing power tools. Such preventive safety measures reduce the risk of
starting the power tool accidentally.
20. Store idle power tools out of the reach of children and do not allow
persons unfamiliar with the power tool or these instructions to operate
the power tool. Power tools are dangerous in the hands of untrained users.
21. Maintain power tools. Check for misalignment or binding of moving parts,
breakage of parts and any other condition that may affect the power
tool's operation. If damaged, have the power tool repaired before use.
Many accidents are caused by poorly maintained power tools.
22. Keep cutting tools sharp and clean. Properly maintained cutting tools with
sharp cutting edges are less likely to bind and are easier to control.
23. Use the power tool, accessories and tool bits etc. in accordance with
these instructions, taking into account the working conditions and the
work to be performed. Use of the power tool for operations different from
those intended could result in a hazardous situation.
Service
24. Have your power tool serviced by a qualified repair person using only
identical replacement parts. This will ensure that the safety of the power tool
is maintained.
VOLTAGE WARNING:
Before connecting the machine to a power source (receptacle, outlet, etc.), be sure
the voltage supplied is the same as that specified on the nameplate of the machine.
A power source with voltage greater than that specified for the machine can result
in SERIOUS INJURY to the user, as well as damage to the machine. If in doubt,
DO NOT PLUG IN THE MACHINE. Using a power source with voltage less than
nameplate rating is harmful to the motor.
-3-
SPECIFICATIONS
Rated Power Input
Rated Speed
External dia.
Thickness
Wheel size
Internal dia.
Net Weight
※Due to the continuing program of research and development, the specifications
herein are subject to change without prior notice.
ADDITIONAL SAFETY RULES
1. Ensure that the power switch is in the OFF position and unplugged before carrying
out any work on the tool.
2. Use your tool at lower input than specified on the nameplate; otherwise the finish
may be spoiled and working efficiency reduced by motor overload.
3. Never operate this power tool without wheel guard. Keep guards in place.
4. Use only wheels with maximum operating speed at least as high as "No-Load
Speed" indicated on the power tool nameplate. When using depressed center
wheels, be sure to use only fiberglass-reinforced wheels.
5. Check the wheel carefully for cracks or damage before operation. Replace cracked
or damaged wheel immediately.
6. Use only flanges specified for this tool.
7. Be careful not to damage the spindle, flanges (especially the installing surface) or
bolt. Damage to these parts could result in wheel breakage.
8. Keep hands away from rotating parts.
9. Make sure the wheel is not contacting the workpiece before the switch is turned on.
10. Before using the tool on an actual workpiece, let it run for a while. Watch for
vibration or wobbling that could indicate poor installation or a poorly balanced
S1M-FF-125A
S1M-FF03-115
850 W
850 W
11800 r/min
11800 r/min
125 mm
115 mm
6 mm
6 mm
22 mm
22 mm
1.8 kg
1.8 kg
-4-