American Time SQA461RSxE Kullanıcı El Kitabı - Sayfa 8
Saat American Time SQA461RSxE için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. American Time SQA461RSxE 15 sayfaları. Wireless digital clock/elapsed time indicator with code blue
Sayfayı Yazdır
Clock/Timer Installation
The Digital Clock/Timer can be mounted to a single or double gang box. To install the Digital Clock/Timer, follow the
instructions below. Ensure that installation conforms to the National Electrical Code and local wiring codes.
CAUTION: Electric Shock Hazard! Ensure that NO electrical power is present on any wire before installation.
u
Remove the 6-32 black screw on the top of the clock which secures the back mounting plate. Mount the back plate to
a single or double gang box. See Figure 2 on page 9.
v
Make electrical connections (hot, neutral, ground) to non-switched electrical circuit wiring using UL approved wire
nuts. Route field wiring away from sharp projections, corners and internal components. For Molex, connect white to
neutral/common, black to positive/hot, green to ground and red to optional correction line if using a wired master.
Note: Voltage is set at the factory. See part number suffix reference.
120vac 50/60 Hz (SQA461RSAE and SQA461RSPE)
24vac 50/60 Hz (SQA461RSBE)
220vac 50/60Hz (SQA461RSKE)
w
Pull the ten wires from the clock to the control station. Keep these ten wires separate from the high voltage wires.
See Figure 1 on page 9. Note: there are two wires (white and green) in the bundle that are not used.
x
Join the two Molex connectors together, placing excess wiring and Molex connectors into the gang box.
y
Slide the clock onto the metal mounting bracket installed in Step 1 and reinsert 6-32 screw from the top of the clock
into the mounting bracket hole. See Figure 2 on page 9.
z
Connect field wiring interconnecting the Clock/Timer with the ATSTCS Control Station to the appropriate
terminals of the Digital Clock/Timer See wiring detail on next page.
Chassis ground MUST be connected to conduit/Earth ground to provide proper protection from electric shock.
CAUTION: Electric Shock Hazard! When making installation, route field wiring away from sharp projections, corners, and
internal components.
Make sure the SiteSync IQ system controller and other equipment is set up and operational. Note: Clocks should
be installed within 24 hours of installing the system controller. After 24 hours, the system controller will enter Quiet
Mode. If your system controller has a keypad, pressing 3-5-7 will disable Quiet Mode for 6 hours
Apply power to the circuit and confirm correct operation.
Upon startup, the clock will flash the version number and then correct on the first valid signal. This should take less
than one minute. If the clock is not updating, review the steps listed above and consult the SiteSync IQ Installation and
Operation Manual for additional troubleshooting assistance.
8
SQA461RSxE Owner's Manual
© American Time