Astin Trew AT 3000 Kullanım Kılavuzu - Sayfa 10

CD Çalar Astin Trew AT 3000 için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. Astin Trew AT 3000 13 sayfaları. Up-sampling with valve output amplifier

Sayfayı Yazdır

the prog button on the remote.

Enter the first track required as per

TRACK SELECTION instructions above.

If you enter the wrong track, press

the

button on the remote and re-

enter.

Then enter up to 19 more track selec-

tions when the display will show 'FULL'

and flash.

Press the play/pause button on facia

/II on remote to play selection.

To cancel the programmed selection,

press the prog button on the remote

again.

MUTE:

Press the mute button on the remote

and the display will show 'MUTE'. The

CD will continue to play silently. Press

'MUTE' again and the CD will again

play. If you are using the ASTINtrew

pre-amplifier, this will also mute as

well.

STOP:

Press the stop button on the facia or

button on the remote to stop the

CD.

7. Valve and fuse replace-

ment.

Replacing the valve in the unlikely

event of failure during the warrantee

period can be carried out by your deal-

er or distributor.

The high quality dual triode valve fitted

in the AT3000 has been selected to

offer an audiophile sound.

If you wish to experiment with alterna-

tive manufacturers' valves after the

warrantee period has expired, ensure

that the factory fitted valve is replaced

with a 6922 type only. Other valve

types may damage the CD Player. If

you attempt to replace the valve, the

following instructions must be adhered

to.

Note: Dangerously high voltages

are present inside the unit, when

powered from the mains supply,

that can KILL.

NEVER open the CD Player when

attached to the mains supply.

A.Disconnect the AT3000 from all

equipment and the mains supply.

Place on a table or work bench

with plenty of space around the

CD Player.

Note: Wait at least 1 hour before

opening the top cover to allow the

valve time to cool down.

B.Undo the 10 x M3 Alan screws

holding the top plate in position.

Put the screws somewhere safe.

C.Remove the top plate, place on a