Donovan Hammer II Kullanıcı El Kitabı - Sayfa 15

Endüstriyel Ekipmanlar Donovan Hammer II için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. Donovan Hammer II 20 sayfaları. Arm system for belly dumps, end dumps, dump bodies & pups

Sayfayı Yazdır

P/N 1809533 Rev. B

Item Part #

Description

1800178 Control Box

1800186 Lower Chain Guard

1800185 Upper Chain Guard

1800404 Chain Guard Bracket

1800802 Screw - #10 x 1" (GL Kit)

D. 1700400 Self-Tapping Screw - 3/8" x 1"

1800998 Bolt - 5/16" x 1" GR5 (GL Kit)

1800990 Lock Nut - 5/16"

M. 1800993 Lock Nut - 3/8"

1800989 Flat Washer - 5/16"

Q. 1800994 Flat Washer - 3/8" GR5

STEP 1: Determine mounting location for crank. Drive shaft

sprocket and crank sprocket must line up to work

correctly.

NOTE: Additional

brackets may be

needed to align

sprockets.

STEP 2: Using crank mounting holes as guide, mark and drill

5/16" holes in box. Fasten with screws

and nuts

, leaving fasteners loose enough for crank

assembly to slide for adjustment.

, washers

sprocket

chain

crank

Manual Crank Installation

STEP 3: To determine chain length, wrap chain around both

sprockets and pull crank assembly up until screws

are in middle of adjustment slots. Mark chain and

remove excess links. Connect ends with connector

link.

STEP 4: Adjust chain tension, having helper pull downward on

crank assembly. When chain can be deflected about

1", tighten screws

lubricate w

medium

oil to keep chain

moving freely

weight