AMERICH iBath Operatör El Kitabı - Sayfa 2

Banyo Armatürleri AMERICH iBath için çevrimiçi göz atın veya pdf Operatör El Kitabı indirin. AMERICH iBath 2 sayfaları.

IMPORTANT SAFETY INSTRUCTIONS:

Warning: Whirlpool bathtubs utilize acrylic and fiberglass materials (which are inherently slippery surfaces), electricity, water, air pressure and suction. The following basic

safety precautions should always be followed when using your bathtub.

READ AND SAVE THESE INSTRUCTIONS

ELECTRICAL REQUIREMENTS

Manufacturer recommends a dedicated 20 amp circuit breaker for each

power cord supplied on your whirlpool bathtub. WARNING - When

using electrical products, basic precautions should always be followed,

including the following:

1. DANGER: Risk of electric shock. Connect only to a supply circuit

protected by a Class A ground-fault circuit-interrupter (GFCI). Test

on a routine basis.

2. Grounding is required. The unit should be installed by a qualified

service representative and grounded.

3. (For built-in and custom units) install to permit access for servicing.

4. Supply 110 Volt electrical outlet. This circuit must be protected by a

ground fault circuit interrupter (GFCI.)

GFCI

outlet

two channel amp

power supply

pertaining to a risk of fire, electric shock, or injury to persons

5. Plug supply cord(s) into electrical outlet.

6. To test the GFCI, do the following:

a. Push the test button;

b. Check to see that power has been interrupted;

c. Push the reset button;

d. Check to see that power has been restored.

If the GFCI does not operate properly during the test, there is a ground

current flowing indicating the risk of electric shock. Do not use this

unit. Disconnect the unit and have the problem corrected by a qualified

service representative before using.

Refer to Operating Instructions for system operations and wiring

diagrams.

transducer

operating instructions

Pairing with Bluetooth® System

To pair with a Bluetooth® device, follow the following steps:

1. Ensure Bluetooth® is enabled on phone/device.

2. On your device, locate the Bluetooth® device list. Select AW360 or

MIL-BTREC

3. If device asks for a passkey, enter digits 0000 and press OK. Some

devices will ask to accept the connection. Your Bluetooth® device

indicates when pairing is complete.

PERFORMANCE

US CA

E87277

i B a t h