Doodle Hog DIY Boombox Speaker Montaj Talimatları - Sayfa 2
Konuşmacılar Doodle Hog DIY Boombox Speaker için çevrimiçi göz atın veya pdf Montaj Talimatları indirin. Doodle Hog DIY Boombox Speaker 3 sayfaları.
Sayfayı Yazdır
K
E
M
I
STEP 4
CONNECT WIRES
Insert the white plugs of the wire from C and the
wire from D into the white sockets on the left side of
E. Take the blue end of the wire from F and plug it
into the blue socket of E. Insert the red plug of the
wire from battery box G into the red socket on E.
COLORED
SOCKETS
BOTTOM
A
TOP
MIDDLE
FLAP
STEP 3
INSTALL PCB BIG BOARD E
Place the rubber gasket K on the silver
handle of the PCB big board E. Thread
the silver handle through the hole in the
cardboard with the green board facing
down. Place the metal gasket M over the
silver handle. Screw metal nut I on top.
Tighten the nut I as much as possible so E
can't move. Optional: use pliers to tighten
the nut.
C
F
E
D
STEP 5
ASSEMBLE BOX
1. The bottom of A: Fold the bottom of
the box A along the crease and insert it
into the two long holes at the bottom
of A. Fold the sides along the crease
and secure with plastic J pieces to the
bottom hole on each side of the box.
TOP
2. The top of A: Fold the top of the box
along the crease. Push the middle flap in
as you fold the top. The middle flap will
insert in the long hole in the middle of
the bottom of the box. Secure the sides
using plastic J pieces in the top hole on
each side.
BOTTOM
J
H
STEP 7
BATTERY BOX G
1. Hold down the two side flaps of the box
and fold down the back panel of the box
G
securing it by inserting the cardboard tabs in
the matching holes. Keep the back flap open
to access the battery box G. Remove the
white paper from magnet L and secure to the
back of the battery pack.
2. Place 3 AA batteries in battery box G.
Remove the sticker sheet from the second
magnet L (two magnets may be stuck
together), and press to the cardboard on the
bottom of the inside of the box to secure.
B
STEP 6
ASSEMBLE VOLUME SWITCH H
E
Ensure the volume knob is turned off, all the way to the left. Gently
press the volume switch H firmly onto the silver handle E until secure.
Back
Flap
L
G
L
STEP 8
INSTALL HANDLE B
Insert the two ends into the holes on top of the box.
@DOODLEHOGCRAFTS
DOODLEHOG.COM