Akuvox A05 Series Hızlı Kılavuz - Sayfa 5

Dokunmatik terminaller Akuvox A05 Series için çevrimiçi göz atın veya pdf Hızlı Kılavuz indirin. Akuvox A05 Series 8 sayfaları.

2.3 Device Installation with Digital Wrist Temperature Detector (Optional)

Fix the two holes of the detector

onto the installation pins on the

wall-bracket either on the left or

right according to your

preference.

Fasten the back cover with four

Torx screws using the Torx

wrench attached.

Hang the device on to the square hanger on the wall

mounting bracket, pull down the device to make it fall

completely on to the square hanger on the wall-mounting

bracket, then use the Torx wrench attached to tighten the

device with the Torx screws.

Tighten the detector on to the inner

threaded bolt with two M3x6 screw

using the Allen wrench attached in the

same way on both side.

Lead the wires from the wall-mount bracket and the detector

through the square hole on the back cover, connecting them

to the corresponding interface of the main board. And then

select a suitable size rubber plug to push all the cables into

the back cover. Fix cable locking plate to the back cover with

two M2.5x6 screws.

Take out the device along with

the back cover， cable locking

plate， rubber plug， and

corresponding screws.

Wire of detector

Installation is completed.

E16/A05