Astor-Bannerman ABW6 Kullanım Kılavuzu & Kurulum Kılavuzu - Sayfa 3
Banyo Armatürleri Astor-Bannerman ABW6 için çevrimiçi göz atın veya pdf Kullanım Kılavuzu & Kurulum Kılavuzu indirin. Astor-Bannerman ABW6 12 sayfaları. Height adjustable basin
Sayfayı Yazdır
The waste plug
To the rear of the tap block is a small rod with a 'knob' fitted to the top. This can be raised and
lowered to open or close the waste plug as required.
Caution: The unit is fitted with a safety mechanism, if the unit encounters an obstruction under
the front portion of the basin whilst travelling downwards it will automatically stop. Pressing the 'Up'
button will allow the obstruction to be removed. Care should be taken to ensure that
whilst the basin assembly is moving downwards there are no obstructions left directly
beneath the basin or rise & fall unit as the safety mechanism is designed to stop the
unit only when the front of the basin is lifted.
If both the 'Up' and Down' buttons are pressed at the same time the unit will not move.
Cleaning
The basin and vanity top may be cleaned using most mild cleaning agents. Chemical agents must
not be used, i.e., drain cleaners, acetone, oven cleaners or acids. The rise and fall unit, mirror and
handset should be cleaned using a warm soapy solution and rinsed with a damp cloth. Attention
should always be paid to instruction labels on the outside of cleaning agent containers.
Troubleshooting
In the unlikely event that problems occur with the unit, carry out the following easy checks to
determine whether or not an engineer is required.
Fault:
The rise and fall unit does not travel up or down
Cause:
The mains power supply has been disconnected for some time and the unit's batteries are
now flat.
Remedy: Examine the green LED fitted to the right hand side of the unit. If the green LED is not
illuminated neither mains electricity nor battery backup are supplying the unit. Examine the mains
fuses/circuit breakers and reset as necessary and ensure that mains voltage is fully reconnected
then press the reset button situated next to the handset connector. If the LED fails to illuminate an
electrician needs to ensure that mains electrical supply is available at the fused spur (a fuse may have
blown elsewhere in the circuit).
Fault:
The rise and fall unit travels upwards but not downwards.
Cause:
There is an obstruction underneath the basin.
Remedy:
Depress the 'Up' button on the handset to gain clearance from the obstruction and then
remove the obstruction. The rise & fall unit may then resume normal function.
If the problem persists after carrying out these remedies, please
contact Astor-Bannerman on the number on the back page:
Page: 3
Version 3 : 01-04-016