DoorBird A1071 Series Kurulum Kılavuzu - Sayfa 4

Medya Dönüştürücü DoorBird A1071 Series için çevrimiçi göz atın veya pdf Kurulum Kılavuzu indirin. DoorBird A1071 Series 12 sayfaları. 2-wire ethernet poe converter

Sayfayı Yazdır

The 2-wire cable between the Sender

and Receiver are limited to maximum

length of 80 meters.

PoE +

Ethernet data

Caution: When using unshielded wires as 2-wire cable (e.g. simple bell-

wire) between the Sender and Receiver please make sure that no other

electricity-carrying wires are close to the 2-wire cable at any time.

Electricity creates a magnetic field which disturbs the transmission of

the Sender and Receiver seriously and leads to instable transmission

of power (PoE) and network data.

STEP 3: SENDER INSTALLATION

Place the Sender at he end of your network cable (coming from your Internet

Router followed by a PoE-Switch / PoE-Injector) and your 2-wire cable begins.

Connect the network cable to the RJ45 jack of the Sender and the 2-wire

cable to the Port "1" and "2" of the Sender. Please take care of the polarity of

the 2-wire cable ("1" and "2").

A PoE-Switch (e.g. D-Link DGS-1008P) or PoE-Injector (e.g. DoorBird Gigabit

PoE Injector or TP-Link TL-PoE150S) in accordance with the PoE standard IEEE

802.3af Mode A (network cable wires 1, 2, 3 and 6) must be used to power the

Sender. You can find further information about PoE here:

http://www.doorbird.com/poe

A Cat.5 network cable with RJ45 plug or better must be used to connect to

the "LAN/PoE" jack of the Sender.

4 4

PoE +

Ethernet data