DoorHan SHAFT-20 Kurulum ve Kullanım Kılavuzu - Sayfa 4
Kapı Açıcı DoorHan SHAFT-20 için çevrimiçi göz atın veya pdf Kurulum ve Kullanım Kılavuzu indirin. DoorHan SHAFT-20 12 sayfaları.
Sayfayı Yazdır•
When performing operation at height, use a stable support.
•
When drilling holes, use protection for hands and face.
•
For fastening the product, use hardware supplied with the operator or other analogous one.
•
Disconnect the supply, when installation, cleaning or other maintenance is being carried out.
•
If the operator is installed on the door with a built-in pass door, an additional safety device should be installed
to prevent operator activation when the pass door is open.
•
Make sure that there will be no jamming of objects between moving and fixed operator elements when the door
is in motion.
•
It is highly recommended to use DoorHan optional equipment as the accessories produced by third-party
manufacturers can damage the automatic system.
•
DoorHan is not responsible for unstable work of the automatic system when using safety devices and accessories,
which are produced by other manufactures without securing approval of DoorHan.
•
Never leave the electric motors in released condition. This may cause uncontrolled movement of the door leaves
and, consequently, their breakdown.
•
Do not use the operator if it needs repair or adjustment as defects in operator installation or improperly installed
door can cause injury.
•
DoorHan shall not be held liable in case of improper installation of the product and damage arisen during
operation.
•
Since the operator does not have a power cord with a plug, the automatic system shall be connected to the
mains supply via automatic switch with a minimum distance of 3 mm between the neighbouring contacts. It is
recommended to use a 10А double-pole circuit breaker.
•
Be sure, there are no foreign objects in a zone of operator action prior to its start-up.
•
Do not make any changes in the automatic system not specified in this manual.
•
Remove a package of the product and dispose of it. Keep the package materials away from children.
•
Never permit children to play in the zone of door movement when the operator is working. Always keep all
operator remote control panels, as well as stationary control buttons out of reach of children.
•
It is allowed to drive or to go only when the door is stopped and the operator is switched off.
•
The content of the manual shall not be a basis for any claim.
•
The manufacturer reserves the right to modify the design of the product and to improve it without notice.
•
The Installation and configuration of the actuator must only be carried out by qualified specialists.
•
After installing the drive, test force according to standards EN 12445 and EN 12453.
WARNING! For safe and correct work of the operator it is necessary to put a mechanical stopper to limit
door leave travel.
WARNING! RISK OF INJURY!
Have a qualified technician lay the cables 220–240V AC. The cables must be laid in protective corrugated
tubes. Avoid contact of cables and moving parts of the door. In case of supply cable damage, use the suitable
type of the cable.
Materials required for installation of Shaft-20 and relevant accessories (if available):
•
Cable 2 × 0.5 mm
(photocell transmitter, stepped control button);
2
•
Cable 4 × 0.5 mm
(photocell receiver);
2
•
Cable 3 × 1.5 mm
(power supply);
2
•
The cables should be appropriately insulated according to their voltage.
4
SAFETY INSTRUCTIONS