DoorHan SHAFT-30 Kurulum ve Kullanım Kılavuzu - Sayfa 3
Kapı Açıcı DoorHan SHAFT-30 için çevrimiçi göz atın veya pdf Kurulum ve Kullanım Kılavuzu indirin. DoorHan SHAFT-30 12 sayfaları. Ip65/60 ip65
Ayrıca DoorHan SHAFT-30 için: Kurulum Kılavuzu (8 sayfalar), Manuel (12 sayfalar)
Sayfayı Yazdır
1.2. TECHNICAL SPECIFICATIONS
Parameters
Power supply
Motor speed
Shaft hole (with key way)
Manual chain length
Shaft speed
Gear ratio
Weight with chain
Dimensions
Thermal protection
Intensity
Oil amount
Engine power
Protection class
Operating temperature range
1.3. OPERATOR PACKAGE
Upon receiving the operator, unpack it and inspect visually. Make sure, that the operator is not damaged. If any damages are
found, please contact your supplier.
The operator components included in the standard package are listed in the following table.
№
1
2
3
Manual operator chain (8 m)
4
External button switch
5
6
2. SAFETY INSTRUCTIONS
WARNING! IMPORTANT SAFETY INSTRUCTIONS! It is important for the safety of persons to follow safety instructions.
Save these instructions.
Follow all instructions since incorrect installation can lead to severe injury.
Shaft-30 was designed for automation of industrial sectional doors. Do not use the operator for other than intended
purposes.
DoorHan shall not be held responsible in case of injury caused by misuse of the product.
Prior to installation make sure that the door is properly balanced and moves smoothly.
Installation must be performed in accordance with the standards EN12453 and EN 12445. For countries, which are not
EC members, these requirements are to be met.
Check if the door conforms to the standards EN12604 and EN 12605 (see documentation accompanying the door). For
countries, which are not EC members, the above mentioned requirements shall be met in order to obtain an appropriate
safety level.
Mechanical units of the door shall conform to the standards EN12604 and EN 12605.
Prior to installation, check that the location of operator installation is suitable by its climatic conditions to technical
specifications of the operator.
Do not install the operator in premises containing quick inflammable substances or other dangerous environments as it
can cause explosion or fire.
During assembly, installation and adjustment use tools specified in section "Tools" of this manual.
Torque
Name
Operator
Bracket
Set of fastenings
User manual
SAFETY INSTRUCTIONS
Characteristics
220–240 V/ 50 Hz
30 N·m
1 400 rpm
25.4 mm
8 m
32 rpm
43:1
15 kg
370 × 230 × 100 mm
120°C
50%
0.25 l
300 W
IP44
–40... +55°C
Quantity
1
1
1
1
1
1
3