DoorHan SWING-3000 Kurulum ve Kullanım Kılavuzu - Sayfa 7
Kapı Açıcı DoorHan SWING-3000 için çevrimiçi göz atın veya pdf Kurulum ve Kullanım Kılavuzu indirin. DoorHan SWING-3000 16 sayfaları.
Sayfayı Yazdır
4.3. InWard Gate openInG
WarnInG! make sure, that the dimension c does not exceed the value indicated in the table below. Otherwise it is
necessary to improve the pole according to the indicated dimension value.
Pole
Mounting plate
1)
fasten the rear bracket with the appropriate fastening plate to the pole, as shown in the picture above, observing
dimensions A and B, namely, the distance between the axis of the bracket's central hole and of the gate hinge shank. The rear
bracket has several holes, which make installation of the operator easier and allow changing of the gate opening angle. depending
on the position of the gate hinges you can lengthen or shorten the rear bracket.
WarnInG! Increase of dimension B results in decrease of the gate opening angle and leaf angle speed, and in increase
of the operator's linear force. Increase of the dimension B results in increase of the gate opening angle, leaf angle speed,
and the operator's linear force.
2)
Install steel end piece and lubricate all the parts with neutral grease.
3)
When the gate is closed, install
the mounting plate on the gate leaf. make
sure, that the front bracket is positioned
horizontally on the same level with the
rear bracket and that the dimension d
has been observed.
Hinge
Gate leaf (closed)
D
Rear bracket
B
Building level
D
swing-3000
opening angle
90°
120°
swing-5000
opening angle
90°
120°
A
Mounting plate
Rear bracket
Mounting plate
Building level
D
Front bracket
operator InstallatIon
a, mm
B, mm
C
, mm
макс
130
130
60
130
110
50
a, mm
B, mm
C
, mm
макс
200
200
120
200
140
70
A
B
Mounting plate
Front bracket
d, mm
720
720
d, mm
920
920
Moving
end part
7