Canon PIXMA MP640 Ağ Kurulum Kılavuzu - Sayfa 13
Hepsi Bir Arada Yazıcı Canon PIXMA MP640 için çevrimiçi göz atın veya pdf Ağ Kurulum Kılavuzu indirin. Canon PIXMA MP640 16 sayfaları. Installing your multifunction
on additional computers
Ayrıca Canon PIXMA MP640 için: Parça Kataloğu (7 sayfalar), Ağ Kılavuzu (24 sayfalar), Ağ Kılavuzu (19 sayfalar), Ağ Kurulum Kılavuzu (19 sayfalar), Kurulum Kılavuzu (8 sayfalar)
Sayfayı Yazdır
Connection Checklist
Check
Check 1
Before connecting the machine, are the computer and network device (router, access point, etc.) configured and can the computer connect to the network?
Configure the computer and network device.
•
For the procedures, refer to the manuals supplied with the computer and network device, or contact their manufacturers.
Check 2
Are the machine and network device (router, access point, etc.) turned on?
Turn on each device.
If the machine is already turned on, turn it off, then turn it back on.
Check 3
Is the firewall function of your security software active?
A message may appear on the computer monitor warning that Canon software is attempting to access the network.
If the warning message appears, set the security software to always allow access.
Check 4
When establishing a connection over a wireless LAN, is the Wi-Fi lamp (A) lit blue?
Press the HOME button, then using the Easy-Scroll Wheel and OK button, select Settings > Device settings > LAN settings > WLAN
active/inactive > Wireless LAN active to enable wireless LAN.
•
After enabling wireless LAN, perform setup again by following the procedures in "Wireless Setup" on page 22 and onward in the printed manual: Getting
Started.
Check 5
Are the access point and machine installed in an open space where wireless communications are possible? Also, is there a microwave oven, refrigerator, etc. nearby?
Install them in an open space with as few obstacles as possible.
To prevent radio interference, leave some space between the installation location and a microwave oven, refrigerator, etc.
A