Canon PIXMA MX350 Ağ Kurulum Kılavuzu - Sayfa 8

Hepsi Bir Arada Yazıcı Canon PIXMA MX350 için çevrimiçi göz atın veya pdf Ağ Kurulum Kılavuzu indirin. Canon PIXMA MX350 34 sayfaları. Cartridge reset
Ayrıca Canon PIXMA MX350 için: Kurulum Kılavuzu (17 sayfalar), Kurulum Kılavuzu (11 sayfalar), Ağ Kurulum Kılavuzu (16 sayfalar), Broşür (2 sayfalar), Ağ Kurulum Kılavuzu (24 sayfalar), Ağ Kurulum Kılavuzu (17 sayfalar), Basitleştirilmiş Servis Kılavuzu (35 sayfalar), Manuel (4 sayfalar)

Sayfayı Yazdır
Canon PIXMA MX350 Ağ Kurulum Kılavuzu

WPS

Cannot connect. Multiple access points are enabled. is Displayed

Action
The message appears when multiple access points are
detected.
Wait for a while, then configure the settings again.

Connection failed. is Displayed

Check
The message appears when an error occurs.
Check the access point settings, then configure WPS
settings again.
•
For details on how to check the settings of the access point,
refer to the manual supplied with the access point or contact its
manufacturer.
•
For the procedure to configure WPS settings of the machine,
refer to "Wireless Setup Using WPS (Wi-Fi Protected Setup)" in
the printed manual: Getting Started.
•
When using an access point that does not support WPS, configure settings manually. For the
procedure to configure settings of the machine manually, refer to "Wireless Setup" in the printed
manual: Getting Started.

Problems during Software Installation

The Machine is Not Displayed (Detected)

Check
A
Check 1
For a wireless connection, make sure that you follow Check 1, 2, 3, 4, 5 and 6 of
"Connection Checklist" on page 15, then click Update (A).
For a wired connection, make sure that you follow Check 1, 2, 3, 7 and 8 of
"Connection Checklist" on page 15, then click Update (A).
Check 2
Is the machine connected to a network?
•
To confirm the connection status, press the Setup button, then using the { } [ ] and OK
buttons, select Device settings > LAN settings > Confirm LAN settings > WLAN setting list
or LAN setting list. Make sure that Connection is set to Active.
If the machine is not connected to a network, perform setup again by following the
procedures in "Wireless Setup" and onward or "Wired Setup" and onward in the printed
manual: Getting Started.
A