Canon PIXMA MX452 Ağ Kurulum Kılavuzu - Sayfa 5

Hepsi Bir Arada Yazıcı Canon PIXMA MX452 için çevrimiçi göz atın veya pdf Ağ Kurulum Kılavuzu indirin. Canon PIXMA MX452 27 sayfaları. Cartridge reset
Ayrıca Canon PIXMA MX452 için: Kurulum Kılavuzu (7 sayfalar), Kurulum Kılavuzu (2 sayfalar), Başlangıç Kılavuzu (4 sayfalar), Manuel (19 sayfalar), Manuel (4 sayfalar)

Sayfayı Yazdır

Preparing to Connect My Multifunction

To My Network

Be sure to prepare an access point.

Important Information You Need Before Adding Your Multifunction

The following information is required to connect to your access point or router.

•

Access Point Name/Network Name:

Also referred to as SSID. A name to identify the specific access point.

Network Key:

•

Also referred to as encryption key, WEP key or WPA/WPA2 passphrase, Pre‐Shared key.

A password required to set to prevent unauthorized access to communication.

Check your access point or router for the following information, and then write it down.

• Wi‐Fi Protected Setup (WPS) Access Point / Router:

When wireless mode is activated on the printer, it will automatically search for a WPS capable access point. If discovered, the printer's

display will notify you to press and hold down the WPS button on the access point. If a WPS capable access point is not detected, continue

the install using the Standard setup procedure.

• Do not connect the supplied USB cable until you are prompted to do so during the installation.

NOTE: For details on how to check the following information, refer to the manual of your access point or router, or contact its manufacturer.

An "Ad‐hoc connection," which establishes a direct

connection to the computer over a wireless connection

without using an access point, is not supported.

<< Previous

Next >>