DoorKing 2372-080 Manuel - Sayfa 2

Tekrarlayıcı DoorKing 2372-080 için çevrimiçi göz atın veya pdf Manuel indirin. DoorKing 2372-080 3 sayfaları. Wireless dual band repeater kit

Sayfayı Yazdır
Automatic UNpaired Communication
Powering up boards will automatically establish communication between them and the baseboard. RF STAT/BASE & REMOTE PAIRED/RF SECURE LEDs will remain
RED on the boards which indicates the boards are communicating with each other, but UNPAIRED. This means that card codes/entry codes/remote codes will be
accepted from ANY tracker board that is set to the same channel and ID setting. See below to PAIR boards if desired.
8
RF RANGE
CH
RESET
PAIRED
8
NET
ON
ID
OFF
RCVD
SYNC LOST
RF STRENGTH
SYNC REVD
DISPLAY
ALLOW
OFF/ON
DENY
HEARTBEAT
STATUS
RF STAT
ONLY red when
it sees unpaired
tracker board.
PROG
LED Display
RF
STAT STRENGTH
T T
T T
T T
S
ST
ST
ST
S S S
S
T
T R
T
TR
TR
TR
TR R
RE E
RE
R R
R R R
R E
R
EN
E
E N
E E
E E
ENGTH
EN
NGTH
NGTH
H
H H
H H
2361 Wireless Baseboard
LED Signal Indicators
LED displays on boards will indicate the signal loss between the boards. A smaller number is a stronger signal. 75 or lower is recommended.
RF STRENGTH LED should be GREEN on each board. YELLOW is marginal strength, RED is poor strength.
2361 Baseboard: LED Display shows the RF Range setting of the baseboard for 2 sec then shows signal loss that the board is actually receiving from 2372 Base side.
2372 Dual Repeater Board: Has LED displays for EACH side of the repeater which shows signal loss for Base and Remote sides.
2358 Tracker Board:
To Display RF Signal Loss
•
Use UP and Down Arrow Buttons
•
Press ENT Button
Pairing Boards Together
When boards are PAIRED: Only card codes/entry codes/remote codes from paired tracker boards will be accepted.
Base Side of 2372: To pair the 2372 Base side with a 2361 Baseboard, the 2372 base side MUST be in an UNPAIRED mode:
Depress the BASE PROGRAM button
Then press the PAIR button
command from the 2361 baseboard, the middle green LED (RF SYNC) and the bottom red LED (RF LOST) blink rapidly; this indicates it has successfully been paired
BASE
with the 2361 Baseboard.
RF STRENGTH
RF SYNC
R R
R R
R R
RF SYNC
RF LOST
T
R R
RF LOST
2373-010
Remote Side of 2372: To pair the 2372 Remote side with the wireless tracker board, unpaired communication must have already been established between the 2.
RF
SECURE
The RF SECURE LED
will remain ON steady red on top of 2358 tracker board. Press the 2372 Remote side PAIRED REMOTE button
until the 2372 REMOTE PAIRED Blue LED
RF
SECURE
the RF SECURE LED
will turn green and remain lit on 2358 tracker board.
Important Notice
Due to the nature of wireless communications, transmission and reception of data can never be guaranteed. Data may be delayed, corrupted (i.e., have errors) or be
totally lost. Although significant delays or losses of data are rare when wireless devices are used in a normal manner with a well-constructed network, DoorKing
wireless products should not be used in situations where failure to transmit or receive data could result in damage of any kind to the user or any other party,
including but not limited to personal injury, death, or loss of property. DoorKing, Inc. accepts no responsibility for damages of any kind resulting from delays or
errors in data transmitted or received using DoorKing wireless products, or for failure of DoorKing wireless products to transmit or receive such data.
Safety and Hazards
Do not operate DoorKing wireless products in areas where cellular modems are not advised without proper device certifications. These areas include environments
where cellular radio can interfere such as explosive atmospheres, medical equipment, or any other equipment which may
be susceptible to any form of radio interference. DoorKing wireless products can transmit signals that could interfere with this equipment. Do not operate DoorKing
wireless products in any aircraft, whether the aircraft is on the ground or in flight. In aircraft, DoorKing wireless products MUST BE POWERED OFF. When operating,
DoorKing wireless products can transmit signals that could interfere with various onboard systems.
Note: Some airlines may permit the use of cellular phones while the aircraft is on the ground and the door is open. DoorKing wireless products may be used at this
time.
The driver or operator of any vehicle should not operate DoorKing wireless products while in control of a moving vehicle. Doing so will detract from the driver or
operator's control and operation of that vehicle. In some states and provinces, operating such communications devices while in control of a vehicle is an offence.
DOORKING
2363-010
14
13
12
11
LED Base Display
6
5
4
3
2
1
BASE
PROGRAM
PAIR
DOORKING
PAIR
(SW1)
2361-010
RLY 1 RLY 2
2372 Wireless Dual Repeater Board
to show Signal Loss number on LED display.
ENT
(SW1) on the 2372 base side for few seconds until the RF LOST LED blinks rapidly and then turns steady RED.
on the 2361 baseboard for few seconds to PAIR with the 2372 BASE side ONLY. Once the 2372 Base side receives a pairing
REMOTE
The BASE PAIRED LED turns green
(D10) blinks rapidly. Once 2358 tracker board has been successfully paired to Remote side of 2372,
BASE PAIRED (D2)
ID
CH
ID
CH
LOW PWR
4
4
4
4
ON
REMOTE
BASE
D10
REMOTE
PAIRED
SW1
BASE
RF RANGE
REMOTE
REMOTE
BASE SIGNAL
BASE
PROGRAM
PROGRAM
POWER
12VDC INPUT
-
RF SYNC
+
2372-011
to select programming Step 21 shown on LED display.
(D2) and will stay lit on 2372 Base side.
LED Remote Display
PAIRED
REMOTE
SW4
PAIRED REMOTE (SW4)
RF STRENGTH
RF STRENGTH
RF LOST
LED Display
2373-010
2358 Wireless Tracker Board
75 or lower is recommended.
DoorKing Technical Support: 1-800-826-7493
RF SECURE
OUTPUT
ALARM
AUX
2358-010
CODE
RELAY
RELAY
RELAY
BAD
NC
NC
NC
ON
NO
NO
NO
1
0
1
21
2
22
3
23
4
24
5
25
6
26
7
27
8
28
9
RF
29
10
30
RF RANGE
11
31
RF ID
12
32
PROGRAM
4
13
33
14
34
1489-010
15
16
17
18
RESET
19
20
ENT
Program Buttons
BASE
REMOTE
RF STRENGTH
RF SYNC
RF LOST
T
R R
RF LOST
2373-010
(SW4) for 3 seconds or