Astralpool QB600 Kullanıcı El Kitabı - Sayfa 15

Yüzme Havuzu Vakumu Astralpool QB600 için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. Astralpool QB600 16 sayfaları.

Sayfayı Yazdır
Astralpool QB600 Kullanıcı El Kitabı
QB robotic cleaner
Message
The cleaner is not climbing
walls.
The cleaner is not moving
The floating cable has
excessive tangling
The cleaner is not cleaning the
pool effectively.

Section 7. Conformity

IEC 60335-2-41
Australian Cert. No. SAA100894EA
3145455L100001-01A
The manufacturer reserves the right to modify these specifications without notice. Although the cleaning robots
have been tested in a large variety of swimming pools, AstralPool cannot be held responsible in the case of a non-
perfect adaptation of the robot to a particular swimming pool.
Owner's Manual
Possible Cause
The filter canister is full or dirty.
Tyre treads worn down.
Confirm appropriate pool
chemistry.
Not connected to electricity.
Cycle not started.
Reset needed.
Too much cable in the water.
Removal needed.
Filter canister is full or dirty.
Brushes are worn.
Cable is excessively tangled.
87002641965
SAA100540
Solution
Dispose of debris and thoroughly clean the filter canister
with mild soap and a soft brush. Then, re-submerge the
cleaner (see: Clean the Filter Canister).
See: Replacing Wear Parts.
Speak with your pool service professional.
Do not leave cleaner in the pool during any chemical
treatments.
The outlet the control unit is connected to, is not supplying
electrical power. Check that the outlet to which the control
unit is connected is receiving electricity.
Press the Start button to initiate a cleaning cycle.
Disconnect the unit power and reconnect after 20 seconds.
If the problem is not resolved, contact your local retailer to
request a diagnostic review or contact AstralPool Consumer
Care 1300 186 875 for Australia or 0800 807 665 for
New Zealand.
Place only the required amount of cable into the water
to allow it to reach the farthest end of your pool with
remaining cable on the pool deck (see: Install and Submerge
the Cleaner).
Untangle the twisted cord and lay in sun to reduce memory
(see: Cord Tangling).
Dispose of debris and thoroughly clean the filter canister
with mild soap and a soft brush. Then, re-submerge the
cleaner (see: Clean the Filter Canister).
Check the wear indicator(s). Contact your local dealer for
spare parts.
Untangle the twisted cord and lay in sun to reduce memory
(see: Cord Tangling).
15