Canon 9540A003 - Optura 400 Camcorder Kullanım Kılavuzu - Sayfa 12

Video Kamera Canon 9540A003 - Optura 400 Camcorder için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. Canon 9540A003 - Optura 400 Camcorder 45 sayfaları. Digital video software (windows) ver.13 instruction manual

Sayfayı Yazdır

Installing the Software

Installing the Digital Video Software

❍ Be sure to install the Digital Video Software before connecting the

camcorder to the computer.

❍ Users of Windows 2000 or Windows XP must first log in as an

Administrator to install programs.

Windows XP Users:

Your digital video camcorder is equipped with the standard Picture

Transfer Protocol (PTP). This protocol enables you to download images by

simply connecting the camcorder to a computer with the USB cable (the

software such as the [Scanner and Camera Wizard] starts automatically).

However, please note that there are several limitations to downloading

images with this method. To avoid these problems, install ZoomBrowser

EX to download images.

❍ It may take a few minutes, after connecting the camcorder, until you

can download images.

❍ Images protected on the camcorder may lose this setting once they are

downloaded to the computer.

Check a camcorder is not connected to the computer.

While a camcorder is connected to the computer, the software cannot be

installed normally. If a camcorder is connected, detach the USB cable from

the computer.

Close any programs that are running.

Set the DIGITAL VIDEO SOLUTION DISK For Windows in the

computer's CD-ROM drive.

• The installer panel opens automatically.

• If the installer panel does not open automatically, use the following

procedures to display it.

Windows 98/Windows Me/Windows 2000:

1. Double-click the [My Computer] icon.

2. Right-click the CD-ROM icon and select [Open] from the displayed

menu.

3. Double-click the [Setup.exe] icon.

Windows XP:

1. Select [My Computer] from the [start] menu.

2. Right-click the CD-ROM icon and select [Open] from the displayed

menu.

3. Double-click the [Setup.exe] icon.

Depending on the setting of your computer, the file extension ".exe" may

not appear.