Canon A-1 Servis Kılavuzu Digest - Sayfa 13
Video Kamera Canon A-1 için çevrimiçi göz atın veya pdf Servis Kılavuzu Digest indirin. Canon A-1 28 sayfaları. Staple finisher and finisher additional tray
Ayrıca Canon A-1 için: Hızlı Kılavuz (14 sayfalar)
Sayfayı Yazdır
Adjustment at Time of Parts Replacement(finisher)
Action on replacing the finisher controller PCB
1) Before replacing the finisher controller PCB, output the service mode setting values by
P-PRINT.
(COPIER > FUNCTION > MISC-P > P-PRINT)
2) After replacing the finisher controller PCB, enter the following item.
However, in this case, the counter cannot enter.
title
Adjusting the Shift Amount of the Shift
roller (Front)
Adjusting the Shift Amount of the Shift
roller (Rear)
2
Adjusting the Front Staple Position
Adjusting the Rear Staple Position
Adjusting the 2-Staple Position
Adjusting the Stapler Needle Pitch (A4)
Adjusting the switchback position
Punch hole position in feed way
Adj of punch hole
rgst pstn
horizontal
2-4
Service mode
Remarks
(LV1)
-
SORTER > ADJUST > AMT1
(LV1)
-
SORTER > ADJUST > AMT2
(LV1)
-
SORTER > ADJUST > INSTP-F1
(LV1)
-
SORTER > ADJUST > INSTP-R1
(LV1)
-
SORTER > ADJUST > STP-2P
(LV1)
-
SORTER > ADJUST > STP-NTN
(LV1)
-
SORTER > ADJUST > CLCT-SB
(LV1)
At the time of punch
SORTER > ADJUST > PNCH-X
unit setting.
(LV1)
SORTER > ADJUST > PNCH-Y
Measures at Time of Parts Replacement.
1) When changed the following parts, clear a part counter value by all means.
title
Shift roller counter
Staple unit counter
shutter unit counter
Punch unit counter
T-2-4
Service mode
(LV1)
COPIER > COUNTER > DRBL-2 > OFST-RL
(LV1)
COPIER > COUNTER > DRBL-2 > FIN-STPR
(LV1)
COPIER > COUNTER > DRBL-2 > DL-STC
(LV1)
COPIER > COUNTER > DRBL-2 > PUNCH
Default value
-
-
-
At the time of
punch unit setting.
T-2-5