Canon A-1 Servis Kılavuzu Digest - Sayfa 22

Video Kamera Canon A-1 için çevrimiçi göz atın veya pdf Servis Kılavuzu Digest indirin. Canon A-1 28 sayfaları. Staple finisher and finisher additional tray
Ayrıca Canon A-1 için: Hızlı Kılavuz (14 sayfalar)

Sayfayı Yazdır

Basic Configuration(Finisher)

Outline of basic operation

■ Non-sort operation

1.Outline

Ejected paper from the host machine is aligned and stacked on the processing tray.

Paper stack is then ejected on the stack tray.

The paper stack is placed at the center in cross feeding direction.

2.Details

• Outline of operation

1) Ejected paper from the host machine is conveyed into the finisher.

2) Before paper trailing edge passes by the entrance roller, the shift roller goes down to press

the paper.

After the trailing edge passes by the entrance roller, the shift roller stops turning.

3) The gripper opens and the shift roller reverses to transport the paper stack to the aligning

plate.

4) The shift roller goes up to release the paper stack and the gripper closes to grip the stack.

5) The above steps repeat themselves up until the number of the paper on the processing

tray becomes 10 (1 for the envelope) or the operation complete signal is issued whichever

comes first.

6) Gripper starts to eject the paper stack on the stack tray.

7) Stack height detection lever moves up to evacuate itself and moves down again to detect

the stacking height when the stack ejection has completed.

Switchback part

Shift roller

Processing tray

Stack tray

Stack height detetion lever

[Non-sort stacking operation]

4-6

Entrance roller

Stapler

Gripper

Trailing edge

Ejection roller

aligning plate

of the host machine

■ Offset operation

1.Outline

Stacking the ejected paper from the host machine onto the processing tray.

Every paper stack consisting of 10sheets of paper is offset and ejected on the stack tray.

2.Details

• Outline of operation

1) 1)through 5) are the same operation as "Non-sort".

6) The shift roller moves to the center or rear-end position and align the paper stack to locate

it at specified shift position.

7) The shift roller goes up to release the paper stack and the gripper closes to grip the stack.

8) The shift roller returns to its idle position and the above steps repeats themselves till the

last paper.

9) Gripper starts to eject the paper stack on the stack tray.

10) Stack height detection lever moves up to evacuate itself and moves down again to detect

the stacking height when the stack ejection has completed.

• Alignment position

Center shift:

No offsetting (Non-sort position)

Rear-end shift:

From the center reference position to the rear-end position;178.5mm