DOOVAC SML-140 Kullanıcı Kılavuzu - Sayfa 9

Su Pompası DOOVAC SML-140 için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. DOOVAC SML-140 11 sayfaları.

Do not touch the surface of the vacuum pump during operation. Otherwise, you

may get burned.

CAUTIO N

If any abnormal noise or vibration is emitted, stop the vacuum pump immediately

VI. M aintenance

CAUTIO N

1. Inle t Filte r maintenance

Check the inlet filter regularly. Clean or replace a dirty filter.

If the inlet filter is very dirty, replace with a new filter.

Foreign matter will seriously damage the vacuum pump. If the inlet gas or

environment is not clean, install an air filter at the inlet pipe.

CAUTIO N

2. Vanes

The SML type products have 4 vanes.

For the first 6,000 hours of operation and for every 3,000 hours of

operation thereafter, remove the cylinder cover, remove the vanes and

measure the vanes' heights (X).

(See the figure on the right).

The minimum allowable vane heights (X) per model are presented in the

Table below. If any one of the vanes has been worn to a height less

than the allowable value, replace all 4 vanes with new ones.

Minimum Allowable

Height (X)

3. Cle aning Cooling Fan and Fan Cover

A dirty cooling fan cover may disturb the

cover regularly.

Troubleshooting

VII.

Problem

Possible Cause

Rated vacuum

Leak at inlet line

pressure is not

SML-030/060

15mm

flow of the cooling air. Check and clean the cooling fan

SML-N60

SML-140

19mm

Troubleshooting

Check the inlet piping. Correct if

there is leakage.

SML-280

31mm

35mm