Akw Onyx Kurulum ve Kullanıcı Bakım Talimatları - Sayfa 2

Sıhhi Tesisat Ürünleri Akw Onyx için çevrimiçi göz atın veya pdf Kurulum ve Kullanıcı Bakım Talimatları indirin. Akw Onyx 4 sayfaları. Low profile shower tray

Sayfayı Yazdır

Step 1

Position the tray over the

desired location for the shower

and mark around the edge of

the shower former.

Step 4

170 mm

220 mm

355 mm

The waste area must be supported

with additional noggins 220 mm

around the waste. Additional

noggins or joists must be used on

all edges and between joists

centres at a minimum of 350mm.

7. The tray should be bedded onto flexible adhesive on the joists and checked it is level

and supported on all 4 sides.

The waste clamping ring should now be fitted to secure and seal the waste to the tray.

Install the waste trap to the tray, see separate waste instructions. The waste cover

should now be secured in place.

Re-check tray is level and test for water drainage efficiency of tray.

Vinyl floor covering or tiles should finish flush and upto the tray as shown below.

The flooring should be laid up to the edge of the tray and sealed with silicone sealant.

The walls should be covered with the waterproof wall covering and then sealed to the

tray with silicone sealant.

Step 7

Plaster

Waterproof wall covering

Silicone Sealant

Wall

Installing into Wooden Floors

Step 2

Cut into the flooring, taking

care not to cut through

supporting joists or any

plumbing or electrical wiring.

Step 5

220 mm

355 mm

Do not cut into the joists,

always drill through when

installing the waste drain trap

and waste outlet pipe.

Joist

Step 3

Carefully remove the floor

boards. Locate the waste

outlet pipe.

Step 6

Water test the waste drain

trap for flow and for any

leaks and ensure that the

rubber seals are in place.

Tiles or Vinyl Floor Covering

Marine Ply

75x50mm

Noggins

On all external edges

Flush

Floor

Boards

Technical Help line

01905 560219