Canon 600F - CanoScan LiDE Hızlı Başlangıç Kılavuzu - Sayfa 8

Tarayıcı Canon 600F - CanoScan LiDE için çevrimiçi göz atın veya pdf Hızlı Başlangıç Kılavuzu indirin. Canon 600F - CanoScan LiDE 46 sayfaları.

Scanning Film

This scanner can scan 35 mm film strips (6 frames at a time). Follow the procedure below when scanning

film.

• Make sure the document glass is wiped clean before placing the film adapter unit on the

scanner.

• Handle the film adapter unit carefully to avoid damaging the glass panel.

• Handle film strips carefully to avoid scratching or leaving fingerprints on them.

Open the film adapter unit by the center latch and remove the protective cloth. Detach

the cable from the retainers on the side of the film adapter unit.

Open the document cover and set the film

adapter unit on the document glass.

Align the dots on the film adapter unit and the dots

on the scanner (labeled [FAU]) to set the unit in

place.

Connect the cable to the connector on

the side panel of the scanner, then

gently close the document cover.

You need to calibrate the scanner before

scanning film for the first time. Do not place a

film strip in the film adapter unit at this point

as it is not required for calibration.

Start ArcSoft PhotoStudio, then start ScanGear.

Follow the steps 2 to 4 in "Try Scanning" on page 4.

Select [Negative Film (Color)] or [Positive Film

(Color)] in [Select Source] to match the type of film

you are scanning, and then click [Preview].

Protective

Cloth