Ametek Solartron Metrology Wigauge WHT Kullanım ve Kurulum Kılavuzu - Sayfa 4

Test Ekipmanları Ametek Solartron Metrology Wigauge WHT için çevrimiçi göz atın veya pdf Kullanım ve Kurulum Kılavuzu indirin. Ametek Solartron Metrology Wigauge WHT 17 sayfaları. Wireless handtool

Sayfayı Yazdır

2.0 Installing a Gauge Head

The WHT is designed to interface to industry standard gauge heads. The standard Wireless WHT unit will interface directly to an M10 x1 threaded gauge head;

M6 x0.75 and threaded gauge heads of other sizes require the use of an adapter.

Caution

Ensure the screw thread of both the WHT and gauge head are clean before

assembly.

1. To assemble the WHT and gauge head, insert and screw the gauge head in to the front

of the WHT by hand, as above.

2. Using a 13 mm spanner, grip the WHT head adapter across the flats.

3. Use a suitably sized spanner to grip the gauge head and tighten the thread to a maximum torque of 5 Nm.

Caution

It is essential to use a spanner to hold the WHT when tightening the gauge head to avoid damaging the hand tool.

Exceeding the maximum torque on the WHT and gauge head assembly can cause damage to both components.

2.0 Installing a Gauge Head

502848 Issue 5