Doran SCC-AM-00 Kurulum ve Kullanım Kılavuzu - Sayfa 11

Ölçüm Cihazları Doran SCC-AM-00 için çevrimiçi göz atın veya pdf Kurulum ve Kullanım Kılavuzu indirin. Doran SCC-AM-00 15 sayfaları. Sleeping child check

Sayfayı Yazdır

1. Basic Operation

 Drill 5/8" hole in access panel in the rear interior of the bus.

 Thread hex nut onto threaded stem.

 Insert switch through hole as shown.

 Adjust hex nut to proper depth to secure switch properly.

 Make a connection from chassis ground (at the rear of the bus) to one

terminal of the reset switch.

 Make a connection from P10 wire to the other terminal or the reset switch.

 Apply Loctite

 Thread cap onto threaded stem and tighten securely.

V. Installation Testing for the SCC Monitor

The inspection procedure listed below should be followed at the completion of the

installation.

1) Start the school bus. Make sure all the doors are closed.

2) Activate the Red warning light flashers and open the door. The "YELLOW" LED

will light on the circuit board to show the system is armed.

3) Turn off the Red warning light flashers and close the door.

4) Turn the ignition key to the "OFF" position. The "RED" LED will blink and the

interior overhead lights will come on (if the overhead light option is hooked up)

Open the front door. The "RED" LED will stay on and the horn should cycle on

and off.

Close the front door and walk to the back of the bus. Depress the reset switch. If

functioning properly, this will disarm the Sleeping Child Check module and the

horn should deactivate. Both LEDs will go out on the printed circuit board. The

interior overhead lights will remain on for one minute if this option is installed.

NOTE

: (alarm will not deactivate with front door open).

Figure 4

Cut-away view of Reset Switch Installation

(non-permanent, serviceable) to exposed threads.