Doran 360SL Kullanım Kılavuzu - Sayfa 6

Test Ekipmanları Doran 360SL için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. Doran 360SL 9 sayfaları. Programming tool

III. ENTERING DATA INTO THE TOOL

SEND INFORMATION TO BOOSTER: This mode allows all information that was input or entered

into to the Programming Tool to be transferred to the Booster. The SmartLink Booster is the only

booster that can be programmed using the tool.

1. Be sure that the booster is powered and operating. Check to see if the red light is on in the

window next to the power cord attached to the booster.

2. The Programming Tool must be within 6 feet of the Booster for the transfer of information to be

successful because of the limited signal range.

3. Use the up and down arrow buttons to select SEND INFORMATION TO BOOSTER and press

the ENTER button.

4. The display will show

5. When the transfer of information is complete, and the signals were accepted, the program tool

will display

SET SUCCESS . This means the transfer of data was complete and successful.

SELECT PRESSURE UNIT: The factory default for the tool is PSI. The tool can be changed from

PSI to kPa or Bar as preferred.

1. Use the up and down arrow buttons to go to SELECT PRESSURE UNIT from the main menu.

2. Then you must press the ENTER button to enter this mode.

3. The display will show which pressure unit is the present default (see figure C).

4. Pressing the ENTER button will cause the Pressure Unit to begin to flash.

5. Pressing any of the arrow buttons will cause the Pressure Unit to change.

6. When you have selected the Pressure Unit that you desire press the ENTER

button to lock this unit into the memory.

7. Press the MENU button to return to the main menu.

When this operation is completed the booster will now be ready to hookup to a tractor that is

equipped with the Doran 360SL system and will be ready to monitor the trailer tires as well as the

tractor tires that were programmed to the 360SL monitor.

Power Source: The power source for the Programming Tool comes from a replaceable 9-volt battery.

Remove the cover on the back of the tool and install a new battery when the original battery that

was included with the tool losses its power.

VERSION INFORMATION: This menu item is to identify version status of the components. Doran

personnel may request this information when you are calling for assistance.

1. Use the up and down arrows keys to select VERSION INFORMATION and press the ENTER

button.

2. The screen will display the relevant version information.

SENDING . This signifies that the tool is transmitting the information.

Select

Pressure Unit

Current Pressure

Unit : PSI

Figure C