Ametek Magnetrol Tuffy Kurulum ve Kullanım Kılavuzu - Sayfa 8
Kontrolör Ametek Magnetrol Tuffy için çevrimiçi göz atın veya pdf Kurulum ve Kullanım Kılavuzu indirin. Ametek Magnetrol Tuffy 8 sayfaları. Liquid level controls with pneumatic switch
Sayfayı Yazdır
Service Policy
Owners of Magnetrol may request the return of a control
or any part of a control for complete rebuilding or
replacement. They will be rebuilt or replaced promptly.
Controls returned under our service policy must be
returned by Prepaid transportation. Magnetrol will repair
or replace the control at no cost to the purchaser (or
owner) other than transportation if:
1. Returned within the warranty period; and
2. The factory inspection finds the cause of the claim to
be covered under the warranty.
If the trouble is the result of conditions beyond our con-
trol; or, is NOT covered by the warranty, there will be
charges for labor and the parts required to rebuild or
replace the equipment.
In some cases it may be expedient to ship replacement
parts; or, in extreme cases a complete new control, to
replace the original equipment before it is returned. If this
is desired, notify the factory of both the model and serial
numbers of the control to be replaced. In such cases, cred-
it for the materials returned will be determined on the
basis of the applicability of our warranty.
No claims for misapplication, labor, direct or consequen-
tial damage will be allowed.
Low Voltage Directive
For use in Installations Category II, Pollution Degree 2.
If equipment is used in a manner not specified by the
manufacturer, protection provided by equipment may be
impaired.
705 Enterprise Street • Aurora, Illinois 60504-8149 USA
630.969.4000 • [email protected] • magnetrol.com
Copyright © 2021 AMETEK Magnetrol USA, LLC
ASSURED qUALITY & SERVICE COST LESS
Return Material Procedure
To efficiently process any materials that are returned, it is
essential that a "Return Material Authorization" (RMA)
number be obtained from the factory, prior to the mater-
ial's return. This is available through your local Magnetrol
representative or by contacting the factory. The following
information is required:
1. Company Name
2. Description of Material
3. Serial Number
4. Reason for Return
5. Application
Any unit that was used in a process must be properly
cleaned in accordance with OSHA standards, before it is
returned to the factory.
A Material Safety Data Sheet (MSDS) must accompany
material that was used in any media.
All shipments returned to the factory must be by prepaid
transportation.
All replacements will be shipped F.O.B. factory.
BULLETIN: 44-606.12
EFFECTIVE: September 2016
SUPERSEDES: May 2010