Astro Pneumatic Tool 1833 Manuel - Sayfa 3

Darbeli Sürücü Astro Pneumatic Tool 1833 için çevrimiçi göz atın veya pdf Manuel indirin. Astro Pneumatic Tool 1833 4 sayfaları. 3/8" nano flex-head angle impact wrench - 400ft/lb

Sayfayı Yazdır
Model:
1833
The oil and water extractor should not be mounted on
or near the air compressor.
The temperature of air is greatly increased during
compression. As the air cools down to room
temperature, in the air line, on its way to the Air Power
Tool, the moisture contained in it condenses. Thus, for
maximum effectiveness, the oil and water extractor
should be mounted at some point
Pitch pipe back toward air receiver
Compressor unit
Drain
Daily
SUGGESTED AIR LINE CONNECTION
PIPE SIZE, I.D. (Inches)
Length of Pipe (feet)
Air Flow
CFM
50
10
1/2"
20
3/4"
30
3/4"
40
1"
50
1"
70
1"
Oil and Water Extractor should be at least 25 ft. from the compressor. Further if possible.
Product Type:
3/8" NANO FLEX-HEAD ANGLE
IMPACT WRENCH - 400FT/LB
in the air supply system where the temperature of the
compressed air in the line is likely to be lowest. Air
lines must be properly drained daily. Each low point in
an air line acts as a water trap. Such points should be
fitted with an easily accessible drain. See diagram
below. Pitch all air lines back towards the compressor
so that condensed moisture will flow back into the air
receiver where it can be drained off.
Drain daily.
Install drain at
each low point
100
150
200
3/4"
3/4"
3/4"
3/4"
3/4"
3/4"
1"
1"
1"
1"
1"
1"
1"
1"
1"
1-1/4"
1-1/4"
25 FEET OR MORE
Page 3
Oil and Water
Extractor
Drain
Daily
Drain Daily