AIR GIZMOS Panel Dock 695 Kurulum Talimatları - Sayfa 2

Yerleştirme İstasyonu AIR GIZMOS Panel Dock 695 için çevrimiçi göz atın veya pdf Kurulum Talimatları indirin. AIR GIZMOS Panel Dock 695 2 sayfaları.

Step 4:

Verify the look and function of the mount

Step 5:

Mark the holes for drilling

Step 6:

Drill the holes

Step 7: Mount the Panel Dock using the supplied hardware

Step 8:

Install the bracket on the back of the GPS

Step 9:

Insert the GPS and attach cables

Congratulations! Your installation is complete. Please email us with any questions you might have at

1100 Jupiter Road, Suite 110, Plano, TX 75074 • (972) 671-8001 tel • (972) 231-3870 fax

With the Panel Dock secured with the edge clamps you can verify that it is at the correct

depth and fits to your liking.

Remove one edge clamp at a time and mark the position of each hole with a pen. Use a

circular motion to mark the outer edges of the hole. This will make it easier to determine

the exact center.

Do this for all four holes, replacing the edge clamps as you go.

There are a number of ways in which you may choose to drill the holes. You can remove

the rails from the panel and drill them on a drill press, or you may use an angle drill to drill

them in the plane. Just be careful to make accurate holes at the marks you made, and

you will be fine.

The bolts we provide have an integral washer on the screw-head side. This provides

adequate distribution of force on the plastic to keep it from cracking. Position the hard-

ware so that the screw head is located on the plastic side and the nut is on the outer side

of the metal rail. Please, be sure not to overtighten the screws, it may result in cracking of

the plastic of the Panel Dock.

Vent Tube: Vent tube can be plumbed for an avionics cooling fan.

Using the four supplied 6-32 black screws, attach the bracket to the back of your GPS.

Tight securely making sure to not overtighten the screws - it may result in cracking of the

bracket.

To install your GPS into the dock, first roll the latch to the full down position. Set the GPS

onto the tabs on the bottom of the Panel Dock and attach your antenna and power cables.

Rock the top of the GPS into the Panel Dock. It may require a bit of pressure, but the GPS

should snap into place. Finally, roll the latch to the up and locked position. This will pull the

GPS securely into the Panel Dock.