Coinco MAG50B Kurulum ve Kullanım Kılavuzu - Sayfa 2
Banka Notu Doğrulayıcı Coinco MAG50B için çevrimiçi göz atın veya pdf Kurulum ve Kullanım Kılavuzu indirin. Coinco MAG50B 2 sayfaları. Bill acceptor
Sayfayı Yazdır
ABOUT THE OPTION SWITCHES
On the MAG50B control board, there is an option switch
module containing eight switches. These switches allow the
unit to be customized. These option switches are factory set
and shipped with switch 3 set to the ON position. This
setting allows the highest acceptance of one dollar bills only,
face up in both directions. If you wish to change these
settings, please refer to "Setting The Option Switches"
section for detailed information.
SETTING THE OPTION SWITCHES
See Figure 1. Remove power to the unit. To access option
switches, remove the bill box to access the option switch
access hole on inner side panel of logic board case. Using a
small screwdriver, set option switches through access hole.
To obtain the highest possible acceptance rate of one
MAG50B Option Switch Settings
Figure 1
dollar bills only, switches 4, 5, 6, 7 and 8 should be set to
the OFF position.
REMOVING ACCEPTED BILLS
See Figure 2. Accepted bills may be removed by releasing
the bill box lid exposing the bills for collection or by
removing the bill box from the bill acceptor unit.
CLEARING JAMS AND CLEANING
See Figure 2. Trapped bills/debris or dirt can result in poor
bill acceptance or bill rejection. Remove bill box and lower
housing to access bill path for clearing trapped bills or
debris. Clean bill path plastic parts with a cloth moistened
with a mild soap and water solution. Clean the magnetic
head and optic sensors using a swab and isopropyl alcohol.
Do not use any petroleum based cleaning solvents,
scouring pads or stiff brushes for cleaning. The
MAG50B requires no lubrication at any time.
)??AFJ
Figure 2
To remove bill box, push tab in
the direction of the arrow and
slide the bill box up.
Flash Codes
A steady light indicates normal operation.
1=Bill Box Full
2=Not Used
3=Check Bill Path
4=N/A
5=Check Optical Sensors
6-14, 17 & 18=Reset or Service Required
15 & 16=Check Skew Sensors
Coinco Publication No. 923817
Pull bill box lid
open to
remove bills.
To service lower housing,
push tab on bottom up
and pull to the rear.
Rev. 1
8/98
Printed in the U.S.A.