Akw M17 DigiPump Kurulum ve Kullanıcı Bakım Talimatları - Sayfa 11
Su Pompası Akw M17 DigiPump için çevrimiçi göz atın veya pdf Kurulum ve Kullanıcı Bakım Talimatları indirin. Akw M17 DigiPump 20 sayfaları. Digipump
Sayfayı YazdırConnecting the Flow Sensor(s) to the Digipump
Connecting the Flow Sensor(s) to the Digipump
Ensure sensor and filter are in an easily accessible location.
Ensure all cables and plumbing are behind water resistant surfaces.
The pump has two flow sensor cables, for mixer showers with two water feeds, both must be
connected to the separate flow sensors. Fit one flow sensor to cold water feed pipe and one to
the hot water feed pipe.
For electric showers only connect one sensor, the other sensor wire must be terminated in a
connector block and insulated using electrical insulation tape at a dry location.
Failure to do this may damage the pump.
Note: To connect the pump directly to a compatible electric shower please see the instructions
supplied with your electric shower.
Flow Sensor
Wire
Ensure the pump spacers are used to prevent the cables from being trapped.
All cable connections must be in a dry location.
Connector Block
Red
+
Brown
S
Black
11
Pump Wire
Red
White
Black