COINTERRA TERRAMINER Kullanıcı Kılavuzu - Sayfa 16

Bilgisayar Donanımı COINTERRA TERRAMINER için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. COINTERRA TERRAMINER 18 sayfaları.

Advanced Screen

The Advanced screen displays four sections of detailed CGMiner statistics divided into four categories:

Summary, Devices, Pools and Stats. If you contact CoinTerra technical support with an issue you may be

required to share some or all of this information in order to aid the troubleshooting process.

To reboot the TerraMiner, briefly press and release the Reset button recessed in the hole on the front

panel with a pin or similar object. The CTR1 LED will turn orange to indicate that the reboot request has

been accepted and then all the LEDs will turn off. After two seconds the reboot process will begin.

You may need to restore the TerraMiner to factory settings for reasons such as losing the Admin

password or after unsuccessfully flashing a newly downloaded firmware. The Factory Restore option

rolls the system back by removing persistent configuration settings such as passwords, CGMiner

configuration and SSL certifications. The currently installed firmware will be retained unless the system

fails to boot, in which case the original factory firmware will be reloaded.

To reset the miner to its default configuration:

Press and hold the Reset button recessed in the hole on the front panel with a pin or similar object



After two seconds the CTR1 LED will turn red, indicating that the button should be released



When the button has been released, the CTR1 LED will blink red while the settings are cleared, after



which the system will restart

If the button is released before two seconds have elapsed, the CTR1 LED will turn orange and the



system will restart without clearing the settings

After clearing the settings it will be necessary to manually reconfigure the system, or by using the



Import Configuration File option to restore a previously saved configuration.

If you press and hold the Reset button for more than 8 seconds the controller

card will shut down but the TerraMiner will continue to operate, although it will

stop mining after a few seconds. If you do this, power down the TerraMiner by

disconnecting both power cords before powering up again.

TerraMiner User Guide