Astro Tool 98SL Manuel - Sayfa 3

Çalışma Işığı Astro Tool 98SL için çevrimiçi göz atın veya pdf Manuel indirin. Astro Tool 98SL 4 sayfaları. Rechargeable dual-beam mini flood worklight

Sayfayı Yazdır

Model:

98SL

ADDITIONAL SAFETY INSTRUCTIONS FOR BATTERY-OPERATED APPLIANCE

• Do not expose the light or battery to excessive temperature.

• Be aware of the risk of terminals of the battery-operated light or battery being short-circuited by metal objects.

• The exhausted battery should be removed from the light and safely disposed of.

• Do not use non-rechargeable batteries in place of rechargeable batteries.

• Do not use modified or damaged batteries.

CHARGING THE BATTERY

Do not expose the battery to extreme conditions such as heat and shocks. There is a risk of injury caused

and by leaking electrolyte solution! In the case of contact, rinse with water or neutralizer.

Seek medical advice if the solution has come into contact with the eyes etc.

The battery must only be charged up in dry areas.

Never charge the light when the temperature is below 4 ºC or above 40 ºC.

Charging indoors only!

Never operate the charger with a damaged power cord or power plug or USB cable.

Damaged cord or plug or cable can result in danger to life due to electric shock.

1. Uncover the cover of USB-C Connect the Micro USB-C plug of the charger cable

to the USB-C socket on the light.

2. Connect the plug of the charging cable to the usb-c socket on the charger.

3. Insert mains plug of the charger into a socket. The Battery charge indicator lights up, When the battery charge

indicator full lights, the charging process has completed and the LED light is ready to use.

4. After charging, first remove the mains plug of the charger from the socket. Then disconnect the USB-C

plug of the charger cable from the light.

INITIAL USE

1. Hold the LED light

2. Press the on/off button

LED switch:

switch on the LED light at its full light intensity mode (100%);

twice: switch on the side COB LED light at its half light intensity mode (50%);

three times: switch off.

COB switch:

switch on the COB light at its half light intensity mode (50%);

twice: switch on the side COB LED light at its full light intensity mode (100%);

three times: switch off.

Position the LED Light

• The LED light may be secured hanging by using the pothook on the end of the LED light.

Pull out of the pothooks from the end and hang the LED light.

• Alternative, set up the LED light to a flat, ferromagnetic surface by using the magnet.

Folding and swiveling the LED light

Product Type:

980 LUMEN RECHARGEABLE DUAL-BEAM

MINI FLOOD WORKLIGHT

Page 3