Ametek 081275 Servis ve Parça Kılavuzu - Sayfa 6

Üfleyici Ametek 081275 için çevrimiçi göz atın veya pdf Servis ve Parça Kılavuzu indirin. Ametek 081275 13 sayfaları. Direct drive regenerative blower

Sayfayı Yazdır

Impeller Shimming Procedure:

WARNING: This unit may be difficult to shim. Extreme care may be exercised.

Tools Needed: Machinist's Parallel Bar

Measure the Following:

Measurements (A) and (B) are made by laying the parallel bar across the housing flange face and

measuring to the proper points. Each measurement should be made at three points, and the average

of the readings should be used.

Shim Thickness = B – (A+C)/2

After the impeller installation (step #4 above) the impeller/cover clearance can be checked with feeler

gauges, laying the parallel bar across the housing flange face. This clearance should nominally be

(A-C)/2.

Vernier Caliper with depth measuring capability

Feeler gauges or depth gauge

Distance from the flange face to the housing (A)

Distance from the flange face to the motor shaft shoulder (B)

Impeller Thickness (C)

Revised – June 2016