Coldelite KW-77 Kullanım Kılavuzu - Sayfa 9

İçecek Dispenseri Coldelite KW-77 için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. Coldelite KW-77 15 sayfaları. Counter model whipped topping dispenser

Sayfayı Yazdır

Part IV - Assembling the Dispenser

Once all of the parts have been washed, rinsed and

sanitized, the dispenser is ready to be assembled.

A) Assembling the Mix Injection Pump

To re-assemble the mix injection pump you must

first locate the parts needed to complete this

assembly. (Refer to figure 4 )

Figure 4

After locating the parts, install the rubber orings.

Lightly coat these with the sanitary lubricant

provided with your dispensers tool kit.

Next apply a light coat of lubricant to each side

and center of the mix injection pump gears.

DO NOT lubricate the gear teeth as this adds no

protective lubrication to the pump. Install the

lubricated gears into the mix pump body.

Lightly lubricate the mix pump shaft seal on both

the inner and outer surfaces. Install this seal into

the rear of the mix pump body.

Install the pump drive shaft into the rear of the

mix pump body ensuring that it is engaged into the

pump drive gear.

Carefully install the pump body into the mix

storage tank. Rotate the pump onto the pump

locking hub ensuring that pump hook stud

engages onto the hub locking pin. Rotate the

drive gear until the shaft engages into the rear

drive coupling. The gear will be completely

enclosed into the pump body if installed properly.

If the gear continues to protrude from the pump

body, continue to rotate while pressing into the

pump body until successful.

Next, install the mix suction tube and spring into

the pump cover well. Rotate the suction tube until

it is locked into place with the lever pointing

away from the rear of the pump.

Install the large oring into the mix pump body

and lightly lubricate. Next, install the pump cover

assembly onto the installed mix pump body.

Secure the mix pump cover to the mix pump

body with the two metal retaining knobs.

NOTE: Hand tighten these knobs only. DO

NOT use any tools to tighten or pump

component damage may occur.