Air Hogs AH Robo Copter Recon Hızlı Başlangıç Kılavuzu

Oyuncak Air Hogs AH Robo Copter Recon için çevrimiçi göz atın veya pdf Hızlı Başlangıç Kılavuzu indirin. Air Hogs AH Robo Copter Recon 2 sayfaları.

Sayfayı Yazdır

Air Hogs AH Robo Copter Recon Hızlı Başlangıç Kılavuzu

Troubleshooting:

Problem

Possible Cause

1. Unit does not operate.

1. Controller/charger AA batteries are depleted or

installed incorrectly as indicated by the low-battery alarm.

2. Robo Copter Recon™ battery is not charged.

3. Crash has damaged the Robo Copter Recon™.

4. Robo Copter Recon™ is not turned on.

1. Robo Copter Recon™ won't lift.

1. Running out of flight battery.

1. Loss of control.

1. Running out of controller/charger battery.

Controller Battery Information:

• Battery installation should be performed by an adult.

• Be careful to install batteries with correct polarity as indicated.

• Do not mix new and old batteries.

• Do not mix alkaline, standard, rechargeable or different types of batteries.

• Different types of batteries or new and used batteries are not to be mixed.

• Exhausted batteries are not to be removed from the toy.

• Non-rechargeable batteries are not to be recharged.

Important Battery Information:

• Charging operation should be performed by adults only.

• Always fully charge the battery in repeat use.

• The supply terminals are not to be short-circuited.

• Do not use the battery with the positive and negative terminals reversed.

• Do not attempt to open, disassemble or short-circuit the

Robo Copter Recon™.

• Stop using and do not recharge the Robo Copter Recon™ that shows

leakage, damage or deformation.

• Do not allow the battery to get wet.

• Always store the Robo Copter Recon™ in a cool and dry place.

• Dispose Robo Copter Recon™ properly and never dispose of battery

pack in fire.

• Do not recharge the Robo Copter Recon™ immediately after use. Wait

until it is cool before charging.

• Do not charge near fire, where temperature is extremely high (flammable

item), or where it is wet or damp.

• Do not leave the battery in direct sunlight.

• DO NOT continue to charge the battery if the charger fails to recognize

full charge. Overheating or swelling of the battery cells is an indicator that

they are in an overcharged condition, and the batteries should be

disconnected from the charger immediately!

Lithium Polymer (LiPo) batteries are very different from other types of batteries and must be handled and disposed of properly. Please refer to and read the

included care and handling instructions for this part.

FCC REQUIREMENTS

This device complies with FCC part 95 of the FCC Rules. Operation is subject to the following two conditions: 1) This device may not cause harmful

interference. 2) This device must accept any interference received, including interference that may cause undesired operation. WARNING: Changes or

modifications not expressly approved by the party responsible for its compliance could void the user's authority to operate the equipment.

Spin Master Ltd., 450 Front Street West, Toronto, ON

M5V 1B6 Canada

registered trademark of Spin Master Ltd. Robo Copter

Spin Master Inc., PMB #10053, 300 International Drive,

Recon TM is a trademark of Spin Master Ltd. All rights

Suite 100, Williamsville, NY 14221, USA

reserved. Manufactured for and distributed by Spin Master

Spin Master Toys Far East Limited. Rm #1113, 11/F,

Ltd. Conforms to product safety standards ASTM F963-03,

Chinachem Golden Plaza, 77 Mody Rd., Tsimshatsui E.,

EN71 regulatory requirements. Products and colors may

Kowloon, HK

vary. Please retain this information for future reference.

Patent Pending. MADE IN CHINA.

North American Consumer Information

Phone: 1-800-622-8339

www.spinmaster.com

#20009979, #20009980 NEN REV 0

Solution

1. Check polarity installation or

replace with fresh AA batteries.

2. Fully charge the battery.

3. Replace the Robo Copter Recon™.

4. Turn on the Robo Copter Recon™.

1. Recharge battery.

1. Replace controller/charger battery.

• Rechargeable batteries are only to be charged under adult supervision

(if removable).

• Rechargeable batteries are to be removed from the toy before being

charged (if removable).

• Only batteries of the same or equivalent type as recommended are

to be used.

• The supply terminals are not to be short-circuited.

• Do not dispose of batteries in fire. Battery may explode or leak.

• DO NOT allow battery to overheat at any time! Cells which reach greater

than 140°F (60°C) can and USUALLY WILL become damaged physically

and could possibly catch FIRE! Always inspect a battery which has

previously overheated for potential damaged, and do not re-use if you

suspect it has been damaged in any way.

• DO NOT allow batteries to be charged or discharged on or near

combustible materials, including paper, plastic, carpets, vinyl, leather,

wood, inside an R/C model or full-sized automobile!

• ALWAYS provide adequate ventilation around batteries during charge,

discharge, while in use and during storage. If a battery becomes

overheated, remove it from the charger IMMEDIATELY and place it in a

fire-proof location until it cools.

• DO NOT modify the battery in any way which might result in permanent

damage or dangerous responses.

WARNING:

Contains LiPo battery pack.

Battery pack must be

recycled or disposed of

properly.

Contents:

1 AH Robo Copter Recon™

1 Controller/Charger

1 Instruction Sheet

Congratulations on your purchase of the AH Robo Copter Recon™. Your AH Robo Copter Recon™ comes

complete and ready to fly (requires 4 1.5 V AA alkaline batteries [not included]) so you can start to fly as soon as

you have thoroughly read the instruction manual and have charged the built-in flight battery.

Key Features:

• Advanced infrared radio control system with digital trims

• Proportional throttle and steering control (2 channels)

• Computer designed figure

• Durable foam body

Safety Precautions:

WARNING: Any change or modification to this product without written approval by the party responsible for compliance

is prohibited.

• Choking hazard: Includes small parts, not for children under age 10.

• Keep everything, especially hair, away from the main rotors and tail rotor when Robo Copter Recon™'s power is on.

• Make sure the controller/charger and Robo Copter Recon™ have their power turned 'OFF' when not in use.

• Keep your Robo Copter Recon™ in sight at all times when flying.

• Do not attempt to charge any battery other than the specified built-in one with the charger in the controller/charger.

• To help to protect your Robo Copter Recon™ from damage, remember to close the throttle (pull the throttle stick down)

immediately to stop the rotors if your Robo Copter Recon™ falls over or hits something.

Special Caution:

Do not touch the PCB (receiver) on your Robo Copter Recon™ with anything, especially metal, to avoid

any unnecessary damage. This is not a consumer serviceable item.

Notes for Adults:

• Examine the Robo Copter Recon™ carefully for any possible damage prior to every flight. Do not attempt to fly until all

damage has been repaired.

• Adult supervision is required when a child is charging the battery in the Robo Copter Recon™ or installing/replacing the

batteries in the controller/charger.

Notes for Maintenance:

• Remove the batteries installed in the controller/charger if you are not going to use this product for a long time.

• Clean the controller/charger's surface with a dry soft cloth if it is dirty. Do not use any water or spray cleaner on the

controller/charger.

• Store this product in a cool dry place.

• Replace the batteries in the controller/charger when you hear the low battery alarm (beeping sound). If you do not replace

the batteries in time, you could lose control of your Robo Copter Recon™ or crash it.

Controller/Charger

AH Robo Copter Recon™

• Built-in LiPo battery for longer flight duration

• Can be recharged using the charge cable inside

the controller/charger

Caution: